Harman Advance Freestanding Pellet Stove Owner's Manual

5 3-90-436168c 4021-645F 02-18-13 Page 2 of 2 WARRANTY CONDITIONS: • This warranty only covers HHT appliances that are purchased through an HHT authorized dealer or distributor. A list of HHT authorized dealers is available on the HHT branded websites. • This warranty is only valid while the HHT appliance remains at the site of original installation. • This warranty is only valid in the country in which the HHT authorized dealer or distributor that sold the appliance resides. • Contact your installing dealer ...

10 3-90-436168c NOTICE Hearth & Home Technologies is not responsible for stove performance or extra maintenance required as a result of using fuel with higher ash or mineral content. Size • Pellets are either 1/4 inch or 5/16 inch (6-8mm) in diameter • Length should be no more than 1-1/2 inches (38mm) • Pellet length can vary from lot to lot from the same manufacturer. Performance • Higher ash content requires more frequent maintenance. • “Premium” grade pellets will produce the highest heat output. • ...

34 3-90-436168c Service Parts Advance Beginning Manufacturing Date: N/A Ending Manufacturing Date: Active IMPORTANT: THIS IS DATED INFORMATION. Parts must be ordered from a dealer or distributor. Hearth and Home Technologies does not sell directly to consumers. Provide model number and serial number when requesting service parts from your dealer or distributor. Stocked at Depot ITEM Description COMMENTS PART NUMBER 26.1 Latch Adjuster, Spring Holder, Door Latch & Spring I Set 1-00-06770 26.2 Screw, 1/4-20 x 3/4” Grade 5 ...

12 3-90-436168c B. Fire Characteristics A properly adjusted fire has a medium active flame pattern that extends out of the burn pot approximately 6 inches (152mm). C. Feed Limit Instructions The Feed Limit control is factory set at #4, and should be adequate for most fuels. However, if the flame height is too high or too low, you will need to adjust the Feed Limit. Wait until the appliance has been burning for 15 minutes before making your adjustments and allow 15 minutes for feed adjustment to take effect. A. Starting Yo ...

18 3-90-436168c CAUTION: Surfaces are hot while in operation, Wear gloves to protect from burns. 1. Open side doors. Figure 5.1 2. Release spring latches on the right and left side of the ash pan. Figure 5.2 3. Slide ash pan forward enough to lift with center handle. Empty ashes and reinstall ash pan. Figure 5.3 Disposal of Ashes: Ashes should be placed in a steel container with a tight fitting lid. The closed container of ashes should be moved outdoors immediately and placed on a noncombustible floor or on the ground, w ...

24 3-90-436168c 6 Troubleshooting and Frequently Asked Questions Status light error messages: 3 Blinks: Indicates that the ESP (Exhaust Sensing Probe) has failed, has a broken connection, or has gone out of range too many times. This requires a manual reset*. 4 Blinks: Can occur only in Room Temp Mode and indicates Room Sensing Probe failed or not installed. If a Room Sensing Probe is then installed, the status light will automatically reset. NOTE: Unit will not start in "AUTO" with this status error. 5 Blinks (In Igniter ...

20 3-90-436168c Slide brick panel straight upward with both hands. While holding the brick panel up with one hand, remove the flame guide from the top of the burn pot. Figure 5.7 Slide the brick panel into the left corner of the firebox with the panel resting on the top edges of the burn pot. Rotate the right side of the brick panel through the door opening. Figure 5.8 Reverse this operation to reinstall the brick panel after cleaning. Firebox Brick Panel Flame Guide/Brick panel holder Burn pot Slide up at these areas. Re ...

33 3-90-436168c Service Parts Advance Beginning Manufacturing Date: N/A Ending Manufacturing Date: Active 25.2 25.1 25.3 25.4 25.5 25.6 25.7 25.8 25.9 25.10 25.11 25.12 25.13 25.14 25.15 Post Serial Number 008360001 Feeder Assembly IMPORTANT: THIS IS DATED INFORMATION. Parts must be ordered from a dealer or distributor. Hearth and Home Technologies does not sell directly to consumers. Provide model number and serial number when requesting service parts from your dealer or distributor. Stocked at Depot ITEM Description COM ...