green-i GITLC Operation & User’s Manual

 Replaces a standard light switch or dimmer  Suitable for lighting, heating or ventilation loads  Turns on for adjustable time period  Illuminated locating ring  Switches all lighting, heating and venti- lation loads up to 10A

BS4662 dimen- sions back boxes. Remove top and bottom lugs if fitted. Use the extender if there is less than 25mm free space. REMEMBER—put the wires through the ex- tender before connecting 1 way switching If the lights are controlled from one location only, wire as in the diagram. This product should be installed in accordance with the current IEE wiring regulations. If in doubt consult a qualified electrician. Do not overtighten May have red or brown sleeve LINK com L1 wiring—1 way switching

2 way switching If more than one time lag switch is required to switch the lighting (e.g. At the top and bot- tom of a staircase) they can be wired in parallel, as in the diagram. LINK com L1 LINK com L1 Locating ring The GITL comes with an LED locating ring which is used to locate the buttons at night. If the load does not turn off properly (e.g. lamp flickers, fan continues to run, contactor does not open) then the LED needs to be disabled. To achieve this, remove the link as shown below. LINK com L1 Remove link to disable LED locating ring

Press for more than 5 seconds to activate (see Activate section). Short press—lights off Press for more than 5 seconds to de-activate (see Activate section). battery operation

Time setting (determined by switch, see below) 5 sec—15min 15min—2hour The lights will turn off after the time setting has fin- ished. Clockwise = longer delay. Standard operation Bottom button de-activated. The lights will turn off automatically, but will not turn off manually. 15min-2hour time range 5sec-15min time range setup

 Press and hold the top button for more than 5 seconds. The red LED will flash to indicate that has activated and the unit will now operate.  If the unit is going to be out of use for prolonged peri- ods (more than 6 months) it should be de-activated by repeating the procedure above with the bottom button. This will help to prolong battery life. activate

 When it needs replacing, a red LED will flash on the front of the unit  Follow the steps opposite to replace the battery  Use only good quality, 9V alkaline batteries type PP3 1. Remove front cover 2. Remove switch cover 3. Lever out battery 4. Replace battery 5. Push into holder 6. Replace switch cover 7. Replace front cover 8. Activate batteries

C.P. Electronics Ltd Brent Crescent London NW10 7XR United Kingdom Tel: + 44 (0) 333 900 0671 Fax: + 44 (0) 333 900 0674 www.green-iswitches.co.uk [email protected] IMPORTANT NOTICE! This device should be installed by a qualified electrician in accordance with the latest edition of the IEE wiring regulations. Due to our policy of continual product improvement CP Electronics reserves the right to alter the specification of this product without prior notice. FM 45789 EMS 534520 troubleshooting Voltage 230VAC +/- 10% Frequency 50Hz Temperature 0ºC to 35ºC Power 10A Compliance BS EN60669-2-1 & BS EN55015 ratings Lights flicker when off Fan does not stop completely when off Contactor does not open when off  Remove the link wire to disable the locating ring—see “wiring” section EU registered design no. 000638069-0003, 000638069-0004 Recycling Information According to the WEEE (2002/96) and Battery directive (2006/66), at end of the life of the product or battery, you must dispose them at an appropriate collection point.