Habey FW-1042 Quick Setup Manual

www.habeyusa.com Quick Setup Guide FW-1042 Description QTY FW-1042 1 Power Cable 1 Rack Mount Ears 2 Rack Mount Screws (Large) 4 Drive Mounting Screws (Small) 4 Packing List Safety Warning: The use and installation of this system should only be performed by professionals. Improper installation of any electronic device or electrical component can result in serious injury or death. Please make sure that all safety precautions are taken into account.

component. Make sure all included parts and accessories are present. Step 1 - Inspect Contents Using a phillips head screw driver, remove the four screws on the sides of the enclosure. Step 2 - Remove Top Cover Remove the drive bracket from the enclosure by removing the screws at the base of the bracket. Mount the 2.5” drive on the top of the bracket. Mount the completed bracket to the enclosure Connect the Power and SATA Cables, Step 3 - Mounting a 2.5” Drive Step 4 - Mounting a 3.5” Drive Remove the drive bracket from the enclosure by removing the screws at the base of the bracket. Mount the 3.5” drive on the underside of the bracket. Mount the completed bracket to the enclosure. Connect the Power and SATA Cables. Using a phillips head screw driver, remove the single screw at the top rear of the enclosure.

Pin SO DIMM. Align notch in memory circuit with corresponding guide on the memory slot. Insert the memory circut at a 45° angle and press the circuit flat and secure it to the memory slot with an audible click on each side of the memory slot. Step 5 - Memory Step 6 - Rack Mounting Mount the ears to the front side of the enclosure by securing the ears to the side of the enclosure with the included screws. Locate the included rack mount brackets (ears). Your system is now ready. Connect the power cable to a power source and press the power button on the front of the system. Step 7 - Hardware Installation Complete

Dimensions 21015 Commerce Pointe Drive, Walnut, CA 91789 www. habeyusa.com Copyright@2014. Habey USA. All Rights Reserved. Version 1. Power PS/2 VGA COM USB2.0 LAN LPT Port PS/2 Line-In Line-Out 425mm / 17” 170 mm / 6.7” 170 mm / 6.7” 44mm / 1.75” 250mm / 9.8”