Dynojet Power commander III Installation Instructions

2006-2007 Yamaha FZ1 Installation Instructions Dynojet Research 2191 Mendenhall Drive North Las Vegas, NV 89081 (800) 992-4993 www.powercommander.com Parts List 1 Power Commander 1 USB Cable 1 CD-ROM 1 Installation Guide 1 Power Adapter 2 Power Commander Decals 2 Dynojet Decals 2 Velcro ® Strip 1 Alcohol Swab You can also download the Power Commander software and latest maps from our web site at: www.powercommander.com The ignition MUST be turned OFF before installation! PLEASE READ ALL DIRECTIONS BEFORE STARTING INSTALLATION Button Adjustment Display Faceplate Buttons USB Port Expansion Port

ger seat. 2 Prop the front of the fuel in the up position. 3 Lay the PCIII in the tail section tem- porarily. Route the PCIII harness under the tail section and go towards the front of the bike. 4 Locate the connector from the main wiring harness to the injector rail and uplug this connector (Fig. A). NOTE: This connector is grey in color. 5 Plug the connectors from the PCIII in- line of the stock wiring harness (Fig. B). 6 Bolt the fuel tank down into position. 7 Remove the bolt on the left hand side of thefuel tank bracket and loosen the right hand bolt enough to route the PCIII harness underneath it (Fig. C). 8 Reinstall the bracket. Fig. A Fig. B Fig. C i420-411 www.powercommander.com 2006-2007 Yamaha FZ1- PCIII USB - 2 PCIII connectors Stock connectors Unplug this connector Route the harness underneath this bracket PCIII harness

to the negative side of the battery (Fig. D). 10 Install the PCIII in the rear section of the trunk (Fig. E). This bike does not have a flat surface to allow you to use the supplied vel- cro. The unit can just lay in the tail section or if you are not using your tool kit the PCIII can be secured using the tool kit band. 11 Make sure all the wires are routed properly. 12 Reinstall the main seat and the pas- senger seat. Fig. D 2006-2007 Yamaha FZ1- PCIII USB - 3 Fig. E Ground wire from the PCIII. i420-411 www.powercommander.com