Akytec MU110-8I Operation & User’s Manual

8 5 Configuration ► NOTICE Before starting Before switching on, make sure that the device was stored at the specified ambi- ent temperature (-20 ... +55 °C) for at least 30 minutes. Parameters of the module can be read, edited and saved with “M110 Configurator” soft- ware (on the CD included). The full list of parameters is shown in the Table 5.1. To control the module via Modbus network refer section 6.3 “Modbus addressing” The module should be configured ...

8 5 Configuration ► NOTICE Before starting Before switching on, make sure that the device was stored at the specified ambi- ent temperature (-20 ... +55 °C) for at least 30 minutes. Parameters of the module can be read, edited and saved with “M110 Configurator” soft- ware (on the CD included). The full list of parameters is shown in the Table 5.1. To control the module via Modbus network refer section 6.3 “Modbus addressing” The module should be configured ...

5 4 Installation CAUTION Improper installation Improper installation can cause serious or minor injuries and damage the module. Installation must be performed only by fully qualified personnel. – The module is intended to be mounted on a DIN-rail or on a wall. For the dimen- sion drawings see Appendix A. – Install the module in a cabinet with clean, dry and controlled environment. For fur- ther details see 2.1. – The module is designed for natural convection co ...

9 Name Parameter Valid value Meaning Default A.Len Address bits 0 8 8 1 11 Addr Device address 1…247 16 Prot Protocol 0 akYtec akYtec 1 Modbus-RTU 2 Modbus-ASCII t.out Time-out, s 0…600 0 Rs.dL Response delay, ms 0…45 2 Output parameters o.alr Safe output status, % 0…100 0 * Invalid network parameter combinations: – prty=0; sbit=0; len=0 – prty=1; sbit=1; len=1 – prty=2; sbit=1; len=1 ...