beautyrest SmartMotion 2.0 Quick Installation Manual

SmartMotion™ models: 1.0, 2.0, 3.0 Nationwide Customer Service Phone 1.888.550.3746 Fax 1.805.979.9399 Email [email protected] Web www.ergomotion.com V_002 02/2016

setting up the base. Place the bed base box in a desired location with the bottom of the box facing up. Remove the binding straps and packing materials, making sure not to puncture the box with any sharp objects. If installing a headboard, please see headboard bracket installation instructions in Owner’s Manual. See Owner’s Manual for complete operating instructions. PART LIST Before discarding the packing materials- ensure all the parts are accounted for. Some parts may be attached to the base or inside boxes, please inspect carefully. PART LIST *King bases will have a spare processor and 5v DC Power BASE SETUP Sleeptracker® SETUP (1) Wireless Remote (3) AAA Batteries (4) Legs & Washers (1) Power Cord (1) Power Supply (1) Power Down Box Optional Equipment: (not included) • Surge Protector • (2) 9V Batteries Only included in split bases: (1) Connecting Strap (1) SmartSync® Cord To sync two bases with the SmartSync™ cord - see installation instructions in Owner’s Manual Uncoil the Power Down Box from the frame and install (2) 9 Volt batteries- not included. Place box on the ground. Ensure that it is easily accessible when the base is turned to its upright position. Uncoil input cord (connected to control box’s power port) and plug into Power Supply. Install the legs by threading the washer over the bolt of the leg with the recessed side facing the leg, and tighten by hand. Do not over tighten. Install (3) AAA batteries in remote control. Quickly test functions to verify proper setup before placing mattress on base. Press FLAT to return the base to a flat position. Carefully flip the base over on to its legs. Important: Two people are required to move the bed base. Do not drag across the floor. Do not rest frame on its side, excessive pressure may damage the legs. Uncoil the Power Cord and connect to the Power Supply. Place Power Supply on the ground and extend from the base. Ensure that the Power Supply and all attached cords are directed toward the desired surge protector. Plug the base and into a power source. A surge protector is strongly recommended. Place the mattress on the base. Select Beautyrest® mattresses* are compatible with the mattress retainer attachment panel installed on the SmartMotion™ bases Test all functions on the base to ensure proper setup. For more information please see Owner’s Manual For customer support, visit www.ergomotion.com or call: 1-888-550-3746 *If the mattress is not compatible with the attachment panel, a mattress retainer bar is available for purchase at: 1-888-550-3746 STEP 1 STEP 4 STEP 5 STEP 6 STEP 7 STEP 8 STEP 9 STEP 2 STEP 3 Please refer to Beautyrest Quick Start Guide for Sleeptracker® download and setup instructions. Visit help.beautyrest.com from your smartphone to download the app and view additional Sleeptracker® product information. QUEEN TWIN KING