Gigatek DSP840 Installation Manual
Read Online
Read the Gigatek DSP840 Installation Manual online using the built-in PDF viewer.
Text of the manual
The following items are used to attach the Display to the Stand.
PILLAR C
DISK
SCREW BAG
WAS-1522
PILLAR B
STAND
PILLAR A
EXTENSION SUPPORT (DSP840)
ACCESSORY UNIT (DSP840)
DISPLAY
1
1. Unlock the Screw to open the Stand Plate.
2. Place the Cable from the Display through the extension
pillars to the Stand.
When extending the height of the Stand, attach the extension
pillars with different heights: Low, Mid-low, Mid-high and
High shown as below to the Stand.
2
Pillar B
Pillar C
Pillar A
Pillar C
Pillar B
Pillar A
Low
Mid-low
Mid-high
High
3. Insert the tab on the Display (or the extension Pillar) into the
hole on the Stand until you feel it clicked.
4. Connect the cable from the Display to the XH connector
inside the Stand until you feel it clicked.
Also connect the enclosed USB cable to the “ USB ”
connector .
J1
JP4
3
5. Cover the Stand Plate back and fasten the screws.
Moun
the sp
ting hole to fit
ecial screw
6. You may use the enclosed mounting screws (one Special
screw and two Wood screws) to fix the Display on the
wooden table surface.
Get the Mounting hole on the Stand Plate to fit the Special
screw first and then fix the two Wood screws.
Wooden table surface
Special screw
Wood screw
4
