Infinite Peripherals Infinea X Operation & User’s Manual

Pass-through sync via iOS Weight (without iOS device) 213 g with battery (7.52 oz.) Dimensions 164mm (L) x 83mm (W) x 27.7mm (H) 6.5in. (H) x 3.3in (W) x 1.1in (H) Buttons • iOS On/Off • Scan button • Battery Status button • Programmable Button • Volume ELECTRICAL Barcode Scanner 2D High Speed Imager (supports all major 1D and 2D barcodes) Battery Capacity User-replaceable rechargeable hard pack Li-ion Battery 3.7V 1900mAh Power Consumption Deep sleep ~20uA Contactless Card Reader (RFID ...

X, the battery should be fully charged. The following table will help you get your Infinea X ready for use. Feature Description Barcode Scanner The Infinea X supports one-dimensional (1D) and two dimensional (2D) barcode symbols, which can be read in any direction (omni- directional). The effective reading distance of the barcode reader varies depending on the barcode size. The barcode scanner is capable of reading barcodes on a LCD screen. Radio Frequency Identification (RFID) The Infinea X has ...

The Infinea X uses the Battery Status indicator button and the Scan button to perform a soft-reset without removing the iOS device. The soft-reset feature cycles the power, allowing the Infinea X to restart. To Reset the Infinea X: 1. Press the Scan button and Battery Status indicator buttons simultaneously for about 3 seconds. The Infinea X main board will reset and provide an audible “beep” as confirmation. 2. Release both buttons to allow the Infinea X to restart. Note: If the Infinea X does not restart, repeat the above steps, as needed. SYNCING YOUR IN ...

Programmable LED Status The Infinea X provides application developers with programmable, multi-color LEDs, as shown in the figure below. Supported Colors: • Red • Blue • Green • Orange For information on programming the Infinea X LEDs, refer to the SDK documentation. ...