Invision CV-EX36 Installation Instructions

Installation Instructions Covert Facial Identification Camera CV-EX36 Exit Watch puts the surveillance camera on the frame of the exit door and is the ideal place to capture close-up and clear video images. To all appearances, the unit is like any height strip found in retail stores. CV-EX36 is ideal for use in banks, convenience stores, gas bars and other retail outlets.  Step One Open the box and unwrap the camera housing. Remove the top and bottom ¼ - 20 Allen head screws and separate the swivel-bracket from the housing. Drill a feed-through hole for the camera cable on the mounting surface 77 ¾” [1.975 m] above the finished floor.  Step Two Feed the wire through the ¾” hole on the swivel-bracket. This Kit Includes:  Vandal resistant metal casing.  Functional and attractive faceplate.  Advanced CCD board camera.  12VDC Regulated power supply.  2.1 mm DC power jack for customer supplied power supply.

www.camdencontrols.com Toll Free: 1.877.226.3369 File: CV-EX36_NF_Man_Rev1.doc Revised:January 7, 2011 Part No.:40-82B092 5502 Timberlea Blvd., Mississauga, ON Canada L4W 2T7  Step Three Center the swivel-bracket to the mounting surface and mark the mounting holes for the bracket on the surface. Secure the swivel-bracket to the surface using installer supplied self-tapping screws for aluminum. If mounting on a soft surface such as drywall, be sure to use wall anchors.  Step Four Completing the housing installation Remove the front face plate of the housing by removing the five white oval head 6-32 screws that secure the plate to the housing. Feed the connected wires through the ¾” hole in the back of the height strip housing. Mount the housing to the swivel-bracket using the ¼-20 Allen head screws at the top and bottom. Place a silver washer between the housing and the swivel-bracket. Place the Allen head screw with the other silver washer through the swivel- bracket and washer. Screw down and secure the top and bottom. Connect the DC Power Jack from the supplied 12 VDC power supply to the DC Power Plug on the back of the height strip housing. Connect the video BNC male to the video BNC female on the back of the height strip housing. Replace the face plate with five white 6-32 screws. Adjust the camera housing right or left to acquire the proper field of view for the installation. Tighten down the Allen head screws and verify that the housing is in position and secure. Warning: This camera requires 12 VDC regulated power If you do NOT use the supplied power supply, DO NOT cut the DC power Plug on the camera housing. A DC Power Jack is supplied and ready for splicing into a customer supplied power supply. Cutting the DC Power Plug and reversing the polarity of the DC Power Input will damage the camera and void the warranty. If you DO NOT wish to use the supplied power supply, we have supplied a labeled adapter which should be used to wire into your 12 VDC regulated power supply.