Hyundai 2013 ELANTRA COUPE Quick Reference Manual

screen. The map mode can be switched between North Up and Heading Up. • Each time the button is pressed, the screen will switch in the order shown below. – Heading Up ° North Up ° Heading Up °. ...

The ESC system is an electronic system designed to help the driver maintain vehicle control under adverse conditions. • To turn the ESC off, press the ESC OFF button. • To turn ESC on, press it again. • System defaults to ON position at start. AUTO MIRROR L R AUTO MIRROR L R eCO SYSteM Active ECO system (automatic transmission) Active ECO system helps improve fuel efficiency by controlling the engine and transmission. Press to activate. An LED will illuminate on the button and the ECO indicator will illuminate in the Instr ...

HeaD lIgHtS anD FOg lIgHtS Parking light OFF Auto light Head light escort Function Head lights may stay on for 30 seconds after exiting and locking vehicle. Press remote lock button twice to turn head lights off. High beam Fog light Turn signals and lane change signals Flashing head lights DrIVer’S MaIn COntrOlS Window Auto down/up (driver’s side only) Press�past�detent�to�fully�open/close window. Outside Rearview Mirrors Press�L�(left)�or�R�(right)�on�the�switch.� Then adjust the mirror by using the directiona ...

PUSH ON OFF PUSH ON OFF PUSH ON OFF NOTE: Do not adjust while driving. 1. Pull the lever downward. 2. Set the angle and distance (if equipped). 3. Pull the lever upward. Telescopic Seat belt aDjUStMent Set the belt extension guide to one of the 3 positions when using the seat belt. See Owner’s Manual for additional seat belt information. 1 2 3 NOTE After adding fuel, always reinstall the fuel cap onto the filler neck by rotating it clockwise until it clicks one time. Failure to do this may result in the Check ...

Hyundai owner website - www.myhyundai.com Bluetooth phone compatibility - www.hyundaiusa.com/bluetooth rear Seat FOlDIng rearVIeW CaMera The rearview camera will activate when the ignition switch is turned ON and the shift lever is in the R (Reverse) position. Rearview display FeatUres and COntrOLs TPMS ECO ...

1. Press the call button . 4. Press the “Add to” button to pair a new mobile phone. 2. Press the “Settings” button on the PHONE screen. 5. Enable Bluetooth on your phone. Input the passkey set within the car system into the mobile phone input window. (The initial passkey is 0000.) 6. Bluetooth connection is successful. 3. Press the “Pairings” button on the SETTINGS screen. NOTE Vehicle must be in Park to complete pairing process. Phone setup (pairing phone) with Navigation Pairing tutorials, phone compatibility and Ope ...