Kutai electronics GCU-3000 Operator's Manual

AUXILIARY BLOCK HEATER STOP START OVER LOAD RUNNING PRE-HEAT ALARM AUX.2 AUX.1 LOW FUEL SW BATTERY + OIL PRESSURE SW REMOTE START REMOTE START TEMPERATURE SW Pick-up Meganetic OIL PRESSURE SENDER(4C) TEMPERATURE SENDER(5C) IDLE CONTROL IDLE CONTROL IDLE CONTROL 1A GCU3000 CONTROLLER 10A 34 15 14 10A 16 LOAD L2 N L1 10A 17 18 19 20 21 10 13 22 8 9 23 24 11 7 12 30 26 25 27 28 29 1 3 5 1A 1A VOLTAGE J2 J1 33 31 35 36 G AVR L2 N L1 32 GOVERNOR CONTACT ...

2.1 Summary The GCU has 3 main control buttons : 1. Auto 2. Manual 3. Off In addition, we have the (UP Arrow), (Down Arrow), (Pen Button) and the (Mute Button). Everything you need to operate the generator is on the front panel. 2.2 AUTO In AUTO, the generator starts & stops automatically under the control of the remote start signal. (Usually from an ATS) Press the AUTO key and notice the screen flashes (AUTO). When the control receives a remote start signal the flashing ...

GCU provides Over-load Protection from the amperages calculated in the GCU. To set the overload protection each unit value is equal to 50 Amps, for example: If you enter 20 then the Over current protection value equals to 20 times 50A or 1000A. When the GCU senses a temporary generator over-load, it starts the timer and waits for the over load to disappear within the time allocated. If the generator over-load is longer than the time allocated, the GCU executes ...

output voltage for a MPU measured directly into a digital voltmeter with the engine running at rated speed 50 or 60 Hz. Some Electronics Speed Controllers or Governors do not allow sharing the MPU with other devices. If a MPU is required for over-speed protection we recommend an extra independent Magnetic Pick-up or a dual coil (MPU) If the GCU is programmed to use an MPU, and the MPU is defective or open or its, unable to read the MPU, the ...

Section Page SECTOIN 1 : INTRODUCTION 1.1 Panel Layout ............................................................................................................................................... 4 1.2 Front Panel Layout...................................................................................................................................... 4 1.3 Unit Dimensions (Measurement : mm) ................................................................................ ...

AUXILIARY BLOCK HEATER STOP START OVER LOAD RUNNING PRE-HEAT ALARM AUX.2 AUX.1 LOW FUEL SW BATTERY + GOVERNOR OIL PRESSURE SW REMOTE START REMOTE START TEMPERATURE SW Pick-up Meganetic OIL PRESSURE SENDER(4C) TEMPERATURE SENDER(5C) IDLE CONTROL IDLE CONTROL IDLE CONTROL 1A GCU3000 CONTROLLER CONTACTOR 10A 34 15 14 10A 16 L3 LOAD N L1 L2 10A 17 18 19 20 21 10 13 22 8 9 23 24 11 7 12 30 26 25 27 28 29 1 3 5 1A 1A VOLTAGE J2 J1 33 3 ...