Neatron NT601 Operating Manual
Text of the manual
DIGITAL UHF WIRELESS MICROPHONE
Notice : The changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment.
IMPORTANT NOTE: To comply with the FCC RF exposure compliance
requirements, no change to the antenna or the device is permitted. Any change
to the antenna or the device could result in the device exceeding the RF exposure
requirements and void user’s authority to operate the device.
Model: NT601
FCC ID.: WOUNT601
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1)
this device may not cause harmful interference, and
(2)
this device must accept any interference received, including interference
that may cause undesired operation.
A. Transmitter (Hand-Held Microphone):
a. Putting 3 new batteries (AA / UM-3) inside the battery housing.
Turning on the power switch. A LED indicator flashes briefly that
shows the microphone is in a good working condition.
b. There is about one second latency when turning on or off
the device.
c. Pushing button + or – to increase or decrease the volume ranging from
0 to 15.
d. Using push-button “CH” for altering the channel ranging from 1 to 36.
e. Batteries are going to be exhausted out in a short period of time and
need to be replaced when the LED indicator continuously flashes
B Receiver :
a. Installing vertically two antennas at the rear of the device.
b. Usi ng Mai n Power swi t ch at t he rear f or
openi ng/shut t i ng t he mai n power source.
Plugging the power connector of the attached AC/DC Adapter
into the “DC IN” socket at the rear of the device.
Turning on the Main Power switch, the front panel will then
lights up.
c. Usi ng Power but t on at t he f ront f or t urni ng on/of f t he
si gnal of t he devi ce.
Pushi ng t he Power but t on at t he f ront panel , t he OLED
screen l i ght s up t hat shows t he recei ver i s i n a
good worki ng condi t i on.
d. Turni ng on t he hand- hel d mi crophone and t hen push t he
but t on “ CHANNEL” at t he f ront panel of t he recei ver
t o i gni t e t he Aut o Scan f unct i on f or t he channel
searchi ng, whi ch requi res 2- 3 seconds t o compl et e.
When compl et i ng, t he di gi t of t he channel on t he OLED
screen of t he recei ver get s set , whi l e t he LED
i ndi cat or of t he hand- hel d mi crophone bri ght l y
sparkl es bri ef l y.
Usi ng t he but t on “ CH” on t he hand- hel d mi crophone f or
al t eri ng t he channel t hereaf t er, i f necessary.
( Not e: But t on “ CHANNEL” on t he recei ver f unct i ons
f or onl y t he purpose of t he i ni t i al channel set t i ng. )
e. OLED screen i ncl udes f unct i ons of Ant enna si gnal ,
Vol ume l evel ( to be control l ed f rom Hand- Hel d mi crophone) ,
Bat t ery l evel ( f or bat t eri es i nsi de t he
Hand- Hel d mi crophone) and Channel i ndi cat i on.
SPECI FI CATI ON:
DIGITAL UHF WIRELESS MICROPHONE
Single Channel, True Diversity
RF: There is no audible harmonic interference that makes it available for more
channels used synchronously.
ADUIO: Neatron digital wireless circuit can enhance S/N rate and Dynamic range,
getting high gain while low white noise, it makes the sound quality Hi-Fidelity.
POWER CONSUMPTI ON I N TRANSMI TTER: Neat ron Transmi t t er consumes an
amazi ng l ow power t hat gi ves t he bat t eri es a durabl e l i f e f or a l ong t i me
usage.
REMOTE CONTROL: Both channel and volume level can be remote controlled from
the transmitter.
AUTO-SHUTTING: The signal of the transmitter shuts down automatically when it
not being used for 5 minutes to avoid interfering other users and meanwhile save the
battery energy considerably.
SPECI FI CATI ONS:
OVERALL SYSTEM PERFORMANCE:
RF Carrier Frequency Range: FCC:902~928MHZ
Modulation：PSK(Phase Shift Keying)
CHANNEL：36CH
Transmitting Channel Set-up: Auto scan
Audio Sampling Specs: 16-bit/ 44.1KHz
DATA Rate: 705.6K bps
Lat ency: 5m Sec.
Audio frequency Response：50-20K HZ ±2dB
Dynami c Range: >110dB. A- Wei ght ed
S/N Rat i o: >100 dB
Working Range: up to 100M (in open area)
RECEIVER (Single Channel):
Reception Mode: Digital Diversity
Receiving Type: Zero IF frequency receiving
Sensitivity: 12dBuV at S/N >= 120dB(A)
Audio output:
Mic level(ψ 6.3mm Phone Jack, Unbalanced):- 64dBv/600Ω
Mic level(XLR Socket, Balanced):- 69dBv/600Ω
Power Input: 90-260V AC/ DC12V@200mA.
ANT SOCKET: 50Ω TNC Connector
Display Panel: OLED (displays Channel, Battery Level, Volume Level and RF Signal
Level)
Dimensions: EIA Standard 1-rack configurations
TRANSMITTER:
RF Power Out: <8mW nominal
RF Carrier Frequency Range: FCC:902~928MHZ / CE:863~865MHZ
Channel selector:1~36CH
