Mobeye PowerGuard CM2100 Operation & User’s Manual

After the previous steps, the Mobeye PowerGuard is ready for use. It is armed (switched on) automatically. In order to switch off (disarm) the Mobeye PowerGuard: - Press the on/ off button at the upper side for 1 second. The green LED switches off to indicate the disarmed status. In the disarmed status the Mobeye PowerGuard will not send alarm notifications. The functions automatic arming and sending a ‘low battery’ message, are still active. In order to switch on (arm) the Mobeye PowerGuard: - Press the on/ off button at the upper side for 1 second. The green LED bl ...

This user manual contains important guidelines for the installation and usage of the Mobeye® device as described in this manual. Please read these thoroughly before you start using the Mobeye® device. In case of damage caused by disregarding the guidelines, the warranty becomes void. The user must regularly check the proper functioning of the device. The manufacturer cannot be held liable for any damage or loss caused by any incorrect use or incorrect functioning of the Mobeye® device. Safety guidelines • The permitted ambient temperature during operation may ...

I If the Mobeye PowerGuard is powered externally and the power fails it sends an SMS text message to the programmed telephone numbers followed by a call (setting ‘ALARM’), following the on/off settings of ‘CALL’ and ‘SMS’. Power restore results in an SMS alert to all numbers. This setting can be set to ‘ALERT’ or ‘OFF’. If the setting is ‘ALERT’ the power failure message and restore will be sent as SMS to the TEL1 (administrator). The setting ‘OFF’ means that no power failure message is sent. The default setting for the ‘power failure ...

For configuration activities the (security) code of the Mobeye PowerGuard must be used. The initial (security) code is ‘1111’. You can change the (security) code to your own code. See section 4.4. 4.3 PROGRAMMING THE SETTINGS BY SMS To program the settings by SMS text message: 1. Make sure the PowerGuard is in program mode (please refer to 4.1). 2. Send an SMS text message with the (security) code and the command. 3. The green LED blinks 3 times to indicate the successful configuration. In case of an incorrect command, the red LED flashes 5 times. SMS messages hav ...