QOLSYS IQ TEMP Quick Install Manual

CHOOSE INSTALLATION LOCATION SPECIFICATIONS SEE REVERSE FOR REMAINING STEPS Features: Low Temp and High Temp Warning • Low Temp alarm: Temperature drops below 40F, restores when temperatures rises above 45F • High Temp alarm: Temperature rises above 100F, restores when temperature drops below 95F Sensor: • Cover tamper • Unique ID for each function • Temperature check every 5 minutes • Battery checked every hour Batteries: (2) -Panasonic CR2032 -Energizer CR2032 -Duracell DL2032 The IQ Temp is designed to alert you if temperatures drop below 40°F or rise above 100°F. This early warning may help you protect your valuables, pets and home from extreme heat or cold in the event of a HVAC or thermostat failure. Mounting Locations Ideally suited for a wide range of applications including: • Bathrooms • Laundry Rooms • Basements *NOTE: Avoid areas that may retain heat, such as furnace rooms or near hot water pipes This is a quick guide for experienced installers only. Refer to http://dealers.qolsys.com (login required)

Qolsys Product #: QS5535-840 STEP 2 STEP 3 Select “Freeze” as your sensor type and customize settings as desired Click “Add” REMOVE BATTERY TABS APPLY ADHESIVE INSTALL IN DESIRED LOCATION *NOTE: Sensor Type “Freeze” (Sensor Group 52) is used for both Low Temp sensors and High Temp sensors. You can customize the Sensor Name to differentiate which one you are learning STEP 4 STEP 5 LEARN INTO PANEL Place your panel in “autolearn" mode STEP 6A STEP 6B Open and close the case to “tamper” the device LEARN AS LOW TEMP (40°F) LEARN AS HIGH TEMP (100°F) Remove both of the batteries Hold the tamper button, insert the batteries, release the tamper button [email protected] Qolsys Inc. proprietary. Reproduction without permission is not permitted. FCC ID: 2ABBZ-RF-CHW-S IC: 11817A-RFCHWS This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. Cet appareil est conforme avec Industrie Canada exempts de licence standard RSS (s). Son fonctionnement est soumis aux deux conditions suivantes: (1) cet appareil ne doit pas provoquer d'interférences et (2) cet appareil doit accepter toute interférence, y compris celles pouvant causer un mauvais fonctionnement de l'appareil. CONTACT TECH SUPPORT GOT QUESTIONS? SECURE CONNECTS USING 319.5 MHz