Morso O Series Instructions For Installation And Use Manual

commend that the stove is installed with at least 10 cm clearance to the wall, this will allow room air to circulate around the stove; also the maintenance of the outside stove is easier. When applied to masonry, a layer of wallpaper is normally classified as a non-combustible surface. Clearance to combustible surfaces in front of stove: Model Distance to combustible materials in front of the stove Ø4 700 mm. The clearances stated above are minimum distances, but consideration ought to be g ...

However, the stove is capable of burning other solid fuels as manufactured smokeless coal or good quality anthracite (stove nuts). BITUMINOUS HOUSE COAL SHOULD NEVER BE USED IN YOUR STOVE. Before burning solid fuel Install the chrome iron basket into the firebox. Lighting with solid fuel All air vents must be fully open during the lighting process. Start by placing 5-10 crumpled sheets of newspaper or 2 firelighters on the grate of the stove; then carefully spread approximately 1 kg of well-dried kindling on the top. Light the pa ...

E-Mail: [email protected] · Website: www.morsoe.com Morsø Jernstøberi A/S - 13.12.2016 - 72000200 IMPORTANT! How to heat safely for the environ- ment and yourself! • Use only dry wood Use only dry (max. 20% moisture content) and untreated wood. The fuel must be split and 8 - 12 cm thick. • Light Light with dry kindling (use 1 - 2 kg). Leave the door ajar and stay close to the stove during the lighting phase. • Good layer of embers Be certain to have a good layer of em- bers before refilling. The wood should light within 2 minutes. ...

b) Let the fire out or eject and safely dispose of fuel from the appliance. c) Check for flue or chimney blockage, and clean if required. Do not attempt to relight the fire until the cause of the fume emission has been identified and corrected. If necessary seek expert advice. Extractor fan There must not be an extractor fan fitted in the same room as the stove as this can cause the stove to emit smoke and fumes into the room. Permanent air vent The stove requires a permanent and adequate air supply in order for it to operate safely and effici ...

b) Let the fire out or eject and safely dispose of fuel from the appliance. c) Check for flue or chimney blockage, and clean if required. Do not attempt to relight the fire until the cause of the fume emission has been identified and corrected. If necessary seek expert advice. Extractor fan There must not be an extractor fan fitted in the same room as the stove as this can cause the stove to emit smoke and fumes into the room. Permanent air vent The stove requires a permanent and adequate air supply in order for it to operate safely and effici ...

rated output is (°C) relative to 20° C Ø4 270 4,1 1.9 Draft conditions If smoke spillage occurs when the fire door is opened, it is probably due to poor chimney draft. This type of stove requires at least 12 pa of chimney draft to achieve satisfactory com- bustion and smoke spillage prevention. However, in cases where the stove door is opened too vigorously you could expect that slight smoke spillage may occur. Draft conditions The chimney’s draft is the resulting ...

Description Product Code Ø4 Riddling Grate 44203300 Coal insert 33000200 Grate Frame - Baffle, lower 33005800 Baffle, upper 33006000 Draft Reducer 73002661 Glass 79000100 Tertiary Baffle 73005961 Back brick 79006900 Side brick 79007000 Guarantee Product Registration MORSØ 10 YEAR GUARANTEE CERTIFICATE Behind every Morsø stove is more than 160 years of dedicated stove design and manufacturing experi- ence. Quality control has always been at the heart of the production process and detailed measures have been put into place at all key stages of ...