Videx 6200 Series Manual 

Fax: 0191 224 4938 Email: [email protected] Web: www.videx-security.com The Power to Secure zZz zZz beep! beep! zZz zZz beep! beep! 6272 Colour screen videophone QUICK GUIDE OVERVIEW RECEIVING A CALL OPEN THE DOOR ART. 6272 Intelligent videophone incorporating a 3.5” Hi-Res full colour active matrix LCD monitor, with “camera recall”, “door open/concierge call”, 2 “service” buttons plus 2 LEDs one for generic use (door opening usually) and one to indicate privacy service enabled. Programmable settings: video mode (coax or balanced), melody and number of rings. Adjustments: call tone volume (2 levels plus privacy position), microphone volume, picture hue, contrast and brightness. During a call LCD color screen Headset Privacy activation and Ring volume adjustement Privacy actived LED Open Door button Service button 1 Service button 2 Open Door LED Brightness display adjustement During a conversation To answer to a call it’s enough to release the handset. Press to open the door. The lightened red LED under the symbol indicates that the door is open (if connected during the installation). ‘Camera Recall’ button

stand-by When the system is in stand-by RING VOLUME ADJUSTEMENT BRIGHTNESS DISPLAY ADJUSTEMENT During a call, a conversation or on camera recall mode In every situation In every situation During an incoming call, with the service enabled, the device does not emit any acoustic signal To set the service buttons, please contact a technical personnel. To set up the service turn the volume switch of the call tone to the left. The LED under the symbol the will illuminate. To stop the service turn the switch to the centre or the right and wait for the expire of the programmed time. The LED expires. During the ‘Camera Recall’ it’s possible: To release the handset to begin the conversation; To push to open the door; To push to set up the secondary service Hang up the handset to close the conversation. When the planned time, established during the installation, is over, the service stops and the system returns to the standby position. Push or to set up the correspondent secondary installed services. Push to set up the ‘Camera Recall’. The display shows the picture recorded with the camera on the outdoor station. Move the switch, under the symbol to the centre for a lower volume and to the right for a higher volume. The position on the left sets up the privacy service. Turn the roller under the symbol to the left to reduce and to the right to increase the brightness.