SEA SURF Series Installation Manual

International registered trademark n. 804888 ® English English 67411010 INSIDE RELEASE SYSTEM WITH PLASTIC KEY Turn counter- clockwise the lock protection door (fig. 23); handle Turn the handle clockwise and then turn the key about 90° degrees counter- clockwise (fig.26); After having relocked the operator, reclose the lock protection to prevent damages through weather. Note: For more safety on the release, we recommend to install the lock kit for SURF release (Cod.12715280) optional. To release operate as follows: 1) 2) Insert the key, p ...

International registered trademark n. 804888 ® CONNECTIONS COM. MOT. MOT.OP. MOT. CL. GROUND 250 With mecc. stops / Without limit switch / Without Encoder 350 Reversible MOT. COM. MOT. OP. MOT. CL. GROUND COM. (-) 350 With mecc. stops and limit switch MOT. 24V MOT. 24V COM. (-) MOT. COM. MOT. OP. MOT. CL. GROUND COM. (-) ENC.DATA ENC.+24 350 With mecc. stops, limit switch and Encoder English English 67411010 ATTENTION: The limit switches must be used only for the connection to the control units and not directly connected to the electric m ...

International registered trademark n. 804888 ® SAFETY PRECAUTIONS: All electrical work should conform to current regulations. A 16 A 0,030 A differential switch must be incorporated into the source of the operators main electrical supply and the entire system properly earth bonded. Always run mains carrying cables in separate ducts to low voltage control cables to prevent mains interference. SPARE PARTS: To obtain spare parts contact: SEA -Zona Ind.le, 64020 S. ATTO Teramo Italia SAFETY AND ENVIRONMENTAL COMPATIBILITY: Don’t waste pr ...

International registered trademark n. 804888 ® Note - Notes - Note - Notas - Anmerkung ...

International registered trademark n. 804888 ® English English 67411010 INSIDE RELEASE SYSTEM WITH PLASTIC KEY Turn counter- clockwise the lock protection door (fig. 23); handle Turn the handle clockwise and then turn the key about 90° degrees counter- clockwise (fig.26); After having relocked the operator, reclose the lock protection to prevent damages through weather. Note: For more safety on the release, we recommend to install the lock kit for SURF release (Cod.12715280) optional. To release operate as follows: 1) 2) Insert the key, p ...

International registered trademark n. 804888 ® 67411010 11. Utiliser exclusivement, pour l’entretien, des pièces SEA originales. 12. Ne jamais modifier les composants d’automatisme. 13. L’installateur doit fournir toutes les informations relatives au fonctionnement manuel du système en cas d’urgence et remettre à l’Usager qui utilise l’installation les “Instructions pour l’Usager” fournies avec le produit. 14. Interdire aux enfants ou aux tiers de stationner près du produit durant le fonctionnement. Ne pas permettre ...

International registered trademark n. 804888 ® English English 67411010 Fig. 13 110 mm Fig. 16 (A) Fig. 14 110 mm Fig. 15 62 mm 38mm 62mm = = 38mm POSITIONING OF THE FRONT FIXATION Once the operator has been mounted on the back fixation close the leaf and do as follows: 1) Release the operator. 2) M 3) Tighten the screw (A) at max 8,5 Nm. ount the operator on the front fixation. ATTENTION: When mounting the operator on the front fixation lubricate the pivot with grease. WARNING: For the proper operation of the actuator and of the limit swi ...