THUNDER TIGER Mister Mulligan 4321 Manual 

Set the trim in neutral position. Set the sticks in neutral position Check the position of rudder and elevator (if these are in neutral). Move the stick to the right. Move the stick to the left. Move the stick up. Move the stick down. Move the stick down and right. RIGHT AND UP UP DOWN LEFT TURN RIGHT TURN NEUTRAL THE DIRECTION OF MOVEMENT (RUDDER AND ELEVATOR) To adjust neutral, unsnap the clevis from the horn and screw in or out Neutral app. 10mm Rudder Elevator app. 10mm Neutral app. 5mm app. 5mm ...

Incorrect Wind Direction Wind Landing 3 ft. Launch firmly into wind straight and level. Do not throw upwards! Example of a turn using only rudder Launch Example of a turn using rudder then elevator ...

fly the Mr. Mulligan. Like a real airplane, you must have an understanding of how to fly the model before launch, or you will probably not be successful. Check at your hobby shop or call the AMA (in the front of this book) for flying clubs in your area. 1.Pre-Flight Checklist ❚ Choose a calm day for your first flights. Never fly in winds over 10 mph. Also, choose an open field with no obstacles or people. ❚ Charge the receiver battery. ❚ Make sure there are no other pilots operating on on the same channel (frequency) ...

46. Locate the wing center cover then trim it along the molded line as shown. 47. Glue the wing center cover in place with epoxy. 48. Epoxy the wing strut mounts in place note the orientation of the ring. 49. Drill 2mm mounting holes on the molded dots. Secure the main wing with two 3x30mm (front wing bolt) and two 3x25mm (rear wing bolt) wood screws. 50. Assemble the wing strut joiner as shown, you will need to thread the threaded rod to the wing strut joiner first then thread the clevis. A needle nose pliers will help thread the rod. Epoxy the two plastic tubes to the joi ...

8. Epoxy left and right fuselage halves together. Note the furnished epoxy is 5-min. epoxy and working time is only 3 min., you will have to quickly apply epoxy on left and right fuselage within 3 minutes. There are more different Epoxy available in 12-min. or 30-min. epoxy which allow longer working time that you can buy in any hobby store. 9.Apply masking tape to hold two fuselage halves together until glue has cured. Glue the plywood front and rear wing mount in place underneath the foam as indicated. Pre-Drill 5/64” (2mm) holes on plywood prior installation. This wi ...

AS6327 Horizontal Tail AS6326 Main Wing AS6329 Wing Strut Rear Motor Mount (1) Front Motor Mount (1) Bushing (2) 370 Super Motor (1) AS6335 Wheel Pant Spacer (1) AS6331 Cowling M3 Nut (2) Main Gear/Shaft (1) Pinion Drive Gear (1) AS6316 Gear Shaft Set 3x20 mm Self-Tapping Screw (2) Control Horn (2) AS6333 Propeller Set AS6314 370 Super Motor Locking Plate (2) Wheel (2) 2.6x10 mm Self-Tapping Screw (3) 3x5 mm Machine Screw (2) AS6334 Canopy AS6312 Snap on Control Horn Cowling Mount Firewall(1) Landing Gear Mount(1) Battery B ...