Portable Rotation 12PRSAT Operation & User’s Manual

Page 2 Warranty All products sold by Portable Rotation Inc. are warranted against defects in material and workmanship for a period of one (1) year from the date of shipment within North America, and for a period of one (1) year from the date of shipment to outside of North America. If you believe this product you have purchased has a defect in material or workmanship or has failed during normal use within the warranty period, please contact Portable Rotation Inc. for assistance at the contact information listed below. If product repair or replacement i ...

Page 24 Input voltage is above maximum operating range of 14.00 VDC. System has stopped motor operations and is now faulted. Turn off the system and resolve over voltage problem. HALTING! Hi Volts Input voltage is below recommended operating range of 11.90 VDC. The controller will continue to work, but the Rotor Unit may not be able to accurately move the antennas causing tracking errors. Warning! Hi Volts Input voltage is above recommended operating range of 13.75 VDC. The controller will continue to work, but the Rotor Unit may not be able to acc ...

Page 6 • 1 - Small Magnetic Compass • 1 - Extra Set of water seals (in small bag) • 1 - User’s Manual Before First Use Inspect the contents of the box and verify that the contents of the box match the above list. Rotor System Power You will need to attach a 12 Volt DC power source to the ends of the provided cable. The cable ships with a 15 Amp Anderson Power Pole connector already installed. If you are going to make your own power cable the Positive lead on the provided power cable has the White Stripe. Note: The controller electronics will ...

Page 28 When the Antenna Auto Calibration option is installed, a turn from any position to 000 degrees will cause the controller to adjust if necessary the azimuth and elevation to 000/000 degrees. A fail safe is built into the software that will cause the Rotor Controller to reset, subsequently causing the Hand Controller to reset if the Min or Max turn count goes 5 degrees beyond 540 degrees from home position. Thus keeping excessive cable wrap from happening. Copyright 2017 © Portable Rotation, Inc. Page 5 • 12VDC 200 mA Accessory power out on R ...