Topeak NINJA C Operation & User’s Manual

Periodically check that NINJA C is seated in handlebar properly. WARNING PULL OUT User's Guide NINJA C GB HOW TO STORE NINJA C IN HANDLEBAR LIMITATIONS Handlebar with minimum 70 mm straight section end Fits inner ø 16.5-20 mm tube Fits grips with end caps MAINTENANCE Loosen bolt and remove end cap of grip on both sides. (Depends on the type of handlebar) (Example for grips with end caps) Turn the cap to expand the rubber ring as little as necessary. Press to adjust the shape of rubber ring as shown. Push NINJA C into the end of handlebar on both sides. If NINJA C does not fit properly into handlebar, adjust tension of rubber ring as necessary and reinstall. PUSH Rubber Ring Chain Pin x 2 Compartment • Fits Road handlebar with minimum 70 mm straight section end. • Fits inner ø 16.5-20 mm tube. • Fits multi-speed chains up to Campagnolo® 11 speed hollow pin chain. • Please read these instructions before first use. Chain Hook 4 mm Allen Key (Chain Pin is not included) Adjusting Knob and Chain Pin Breaker • Lubricate and maintain tool with Teflon® based lubricant as needed. • To prevent rusting, keep tool dry. STEP 1 STEP 2 3 STEP Cap Rivet Anvil of hollow pin 1 2 3 ø 16.5 mm ø 20 mm ROAD HANDLEBARS FLAT BARS 70 mm 70 mm

HOW TO INSTALL CAMPAGNOLO® 11-SPEED HOLLOW CHAIN PIN WARNING User's Guide NINJA C 2-year Warranty: All mechanical components against manufacturer defects only. Warranty Claim Requirements To obtain warranty service, you must have your original sales receipt. Items returned without a sales receipt will assume that the warranty begins on the date of manufacture. All warranties will be void if the product is damaged due to user crash, abuse, system alteration, modification, or used in any way not intended as described in this manual. * The specifications and design are subject to change without notice. Please contact your Topeak dealer with any questions. For USA customer service, call: 1-800-250-3068 www.topeak.com WARRANTY M-TNJ-C-GB 10/15 Copyright © Topeak, Inc. 2015 After pressing the special replacement pin into Campagnolo® 11- Speed chain and breaking off the guide portion, the break off end of the chain rivet is required to be peened to prevent chain failure. * Campagnolo® is a registered trademark of Campagnolo S.r.I. * Teflon® is a registered trademark of DuPont. 3/4 Turn Use Primary Chain Link Fence to install or remove chain pin. Use Secondary Chain Link Fence to loosen stiff links. Primary Chain Link Fence Secondary Chain Link Fence When pressing in the chain pin, push down on the top of the chain to keep it fully engaged in the chain tool cradle. Make sure the press pin of the chain tool is centered against the chain pin. Inspect chain rivet again and be sure chain links can bend freely after replacement. Press out old chain pin and replace with new chain pin. Hook chain and hold the target chain rivet in center position. The rivet anvil might be too tight to release after use. Lift rivet anvil with chain hook for storage. Snap off new chain pin guide. 1 2 Target chain rivet Press chain pin as little as possible to loosen stiff link if necessary Before After 3 1 2 3