Toa MX-106 Operating Instructions Manual

Features ................................................... 2 Front Panel [Names of components & their usage] .............. 3 Rear Panel [Names of components & their usage] ............... 4 Connection Examples ........................................ 5 Input Connections ........................................... 6 How to get a good mix ...................................... 7 Block and Level Diagrams ................................... 8 Specifications ............................................... 9 Characteristics ...

–133dBm (IHF A) –102dBm (IHF A) –93dBm (IHF A) –72dBm (IHF A) Frequency Response +0, -3dB 30Hz~20kHz (HIGH Zinput TRIM at "0" position.) Equalization 63Hz ±12dB Peaking 125Hz ±12dB Peaking 250kHz +12dB Peaking 500Hz ±12dB Peaking 1kHz +12dB Peaking 2kHz ±12dB Peaking 4kHz ±12dB Peaking 8kHz ±12dB Peaking 16kHz ±12dB Peaking Peak Indicators Red LED on each input channel LED's turn on at 3dB below clipping. INPUT SPECIFICATIONS CONNECTION CH1 CH6 AUX (1~2) EFF/RET GEQ PWR/AMP INPUT LOW Z HIGH Z —— —— —— —— ACTUAL LOAD IMPEDAN ...

to the inputs of other equipment. 1. Properly match the impedances of the outputs and inputs. 2. Connect low impedance outputs to high impedance inputs. It goes without saying that not only input and output impedance matching but also level matching should be taken into consideration. Each input channel of the MX-106 is provided with an input TRIM control, so the usable signal level range is very wide. Input impedances and levels are shown in the following table. INPUT SPECIFICATIONS CONNECTIO ...

GEQ POWER AMP POWER BAND WIDTH POWER AMP TOTAL HARMONIC DISTORTION POWER AMP COMPRESSOR Appearance - 10 - ...

Power Amplifier Input Jack (PWR AMP) The PWR Amp input jack allows the internal power amplifier to be used with external equip- ment. When a plug is inserted, the power amp is automatically disconnected from the MX-106 mixer section. The nominal input level is +4dB with an input impedance of 10k ohms. Program Output Jack (PGM OUT) The PGM Out jack is provided for connection to external equal- izers and/or power amps, deriv- ing its signal prior to the internal GEQ and power amp. Nominal output level is +4dB with an impedance of 600 ohms. Effects Output Jack ( ...

–133dBm (IHF A) –102dBm (IHF A) –93dBm (IHF A) –72dBm (IHF A) Frequency Response +0, -3dB 30Hz~20kHz (HIGH Zinput TRIM at "0" position.) Equalization 63Hz ±12dB Peaking 125Hz ±12dB Peaking 250kHz +12dB Peaking 500Hz ±12dB Peaking 1kHz +12dB Peaking 2kHz ±12dB Peaking 4kHz ±12dB Peaking 8kHz ±12dB Peaking 16kHz ±12dB Peaking Peak Indicators Red LED on each input channel LED's turn on at 3dB below clipping. INPUT SPECIFICATIONS CONNECTION CH1 CH6 AUX (1~2) EFF/RET GEQ PWR/AMP INPUT LOW Z HIGH Z —— —— —— —— ACTUAL LOAD IMPEDAN ...