AUDIO TELEX ACM250P Specifications

mounted but is packaged as self standing with rubber feet. The ACM250P features a flat screwdriver accessible gain control on the rear panel. Inputs The ACM250P features two signal inputs. The unit has industry standard 3 pin XLR microphone sockets. Two line level sockets are provided for bridged in/out connection. Outputs The ACM250P features 100 volt, 70 volt and 4 ohm isolated transformer outputs. Protection Internal current limiting protects the amplifier from both overload and overdrive conditions. The ACM250P also features protection in the form of excess temperature auto cut out. An in built auto temperature sensing fan will turn on at a factory default level but in most situations, will never be required. Manufacture The ACM250P is proudly designed and manufactured in Australia. ACM250P 250w Power Amplifier

The 250 watt power amplifier shall be designed to run 100 volt line audio systems. The unit shall also features a four ohm output. The amplifier may be desk mounted as standard or rack mounted with the addition of an optional rack mount kit. The unit shall feature high temperature protection with front panel indication. An in built auto temperature sensing fan shall cool the unit when required and automatically turn off again once the amplifier is running at the correct temperature. The amplifier must be capable of delivering 250 watts into a fourty ohm inductive load with less than 0.5% distortion measured at 1kHz and with system hum and noise less than –74dB. The amplifier shall be an Audio Telex model ACM250P, manufactured in Australia. Power Output 250 watts RMS Maximum Load 40 Ohms @ 100 Volts Power Bandwidth 60Hz-15kHz< O.5% THD Frequency Response 60Hz-15kHz (+/- 3dB) Total Harmonic Distortion 0.5% @ 1 KHz rated power Signal To Noise Ratio -80dB Input Sensitivity 700mv Outputs 100v 70v 4 ohm AC M 250P Specifications Controls One gain control on rear of the unit via flathead screwdriver control. Indicators Power "on" and “Protect” LED Power Source AC 240v-60Hz, 110v-50Hz (special) 3 pin IEC connector Power consumption 400 watts. Protection Current Limiter protection, plus AC and DC fuses Dimensions / Weight 88mm H x 480mm W x 330mm D (Chassis Dimensions only), 15kg Rack Mounting Optional ACMRK Rack mount kit Audio Telex Communications Pty Ltd www.audiotelex.com.au Sydney (02) 9647 1411, Melbourne (03) 9890 7477, Brisbane (07) 3852 1312, Perth (08) 9228 4222 Auckland (09) 415 9426, Adelaide (08) 8352 4444, Hobart (03) 6228 6373 A.C.N: 001 345 482