Snow Performance 20001 Installation Instructions Manual
Text of the manual
© 2010, Snow Performance, Inc
Notes
The contents of this document are subject to change without prior notice.
No part of or this entire document may be reproduced in any form
without prior written permission of Snow Performance, Inc under the
copyright except for private use.
The names, addresses and telephone numbers mentioned are current as
of January 1,
© 2010, Snow Performance, Inc
CONTENTS
Kit Contents
3
Installation – Mechanical
4
Installation – Electrical
11
Testing the System
12
Tuning Quick Reference/Maintenance
13
Fluid Level Switch
15
Solenoid Upgrade (Optional)
16
Install Notes
17
Warranty/Disclaimer
18
Have a question?
FAQ: www.snowperformance.net/faqs.php
CAUTION
You must completely read tho
© 2010, Snow Performance, Inc
Snow Performance, Inc. warrants that the Product shall conform to and perform in
accordance with published technical specifications and shall be free of defects in materials
and workmanship for 90-days providing:
1. You are the original purchaser and provide proof of purchase.
2. For 1-year warranty, the Warranty Card that ca
© 2010, Snow Performance, Inc
The boost switch has three prongs. The prong labeled “NO3”is for 12V key-on
power, and the prong labeled “COM” connects to the relay’s red wire. Note that that
are two red wires on the relay harness. The red wire immediately next to the green
wire is for the LED indicator light. The red wire with its own dedicated te
© 2010, Snow Performance, Inc
Solenoid Upgrade (optional)
The optional Solenoid Upgrade (#40060) is required if the nozzle is to be
installed after the intake throttle plate (as shown), or the fluid reservoir is
mounted higher then the nozzle. It is highly recommended for trunk-
mount reservoirs.
Finger thread the two 1/8” NPT quick connect fittings into
