mxr Dyna Comp Deluxe User Manual/operation Instructions

tweakable than ever, featuring the superior vintage tone of the CA3080 “metal can” IC, an Attack switch to toggle between slow and fast attack times, a Tone control, and a Clean control to blend in your uncompressed signal. M228 92503021618REVA jimdunlop.com/m228

1 CLEAN knob adjusts wet/dry signal mix added to the compressor’s ouput 2 OUTPUT knob adjusts volume of compressed signal 3 ATTACK switch toggles between slow & fast attack times 4 TONE knob shapes EQ of compressed signal 5 SENSITIVITY knob adjusts sustain time 6 FOOTSWITCH toggles effect on/bypass (blue LED indicates on) External Controls 2 1 4 6 5 3

Basic Operation 1 Run a cable from your guitar to the M228’s INPUT jack and run another cable from the M228’s OUTPUT jack to your amplifier. 2 Set controls to their 12 o’clock positions. 3 Turn the effect on by depressing the footswitch. 4 Push ATTACK switch to toggle between default slow attack time and fast attack time, indicated by red LED. 5 Rotate OUTPUT knob clockwise to increase effect volume or counterclockwise to decrease it. 6 Rotate SENSITIVITY knob clockwise to increase sustain time or counterclockwise to decrease it. The Dyna Comp® Deluxe Compressor is powered by one 9-volt battery (remove bottom plate to install), the Dunlop ECB003 9-volt adapter, or the DC Brick™ and Iso-Brick™ power supplies. Power Operation

Specifications Input Impedance 600 kΩ Output Impedance 25 kΩ Max Input Level -5 dBV Max Output Level +2 dBV Max Compression 36 dB THD* 0.2% Noise Floor** -100 dBV Current Draw 11 ma Power Supply 9 VDC * Measurements made at -20 dBV, 1 kHz ** A-weighted, all controls mid position