MSA Ultima OPIR 5 Manual 

Applications • Offshore platforms • FPSO’s • Gas plants • Around spherical tanks • Down the length of several bullet tanks • Compressor stations • Fence line monitoring • Rail and truck load outs • Landfills • Urban industrial settings

• Use two people for alignment, one at Source and one at Receiver • Automatic gain control compensates for dirty optics, rain, and fog • Source and Receiver should not be mounted close to radio sources or similar equipment • Mount away from sources of excessive vibration and high voltage/high current power lines • If the path length is less than 20 meters (65 feet), a Source with an attenuation plate is required • A Long Range Alignment Kit is recommended for separations of 60 meters or more • If using adjacent detectors, install Receivers at opposite ends to prevent light interference measurement errors • Field calibration is not required and the sensitivity can be checked by placing a test gas film in front of the Receiver Specification Ultima OPIR-5 RESPONSE TIME (T90, S) ≤3 REPEATABILITY <±5% LINEARITY <±5% FS or ±10% Applied Gas PATH LENGTH, MAX (M) 30 (short), 100 (standard) OPERATING TEMPERATURE RANGE ( °C) -55 to +65 SOLAR BLIND All conditions FOG IMMUNITY BASED ON FM 6325 95% blockage COMBINED WEIGHT, RECEIVER AND SOURCE (KG) 11 (SS only) SUPPLY POWER, NOMINAL (W) 23 BIDIRECTIONAL COMMUNICATION HART, Modbus EVENT LOGGING/AMS DEVICE MANAGER Available TWO AVAILABLE SCALES LIGHT HYDROCARBONS HEAVY HYDROCARBONS 0-5000 ppm*m & 0-5 LEL*m 0-2000 ppm*m & 0-1 LEL*m Typical AJ Values Distance 20 m 50 m 100 m STANDARD 50-60 40-50 25-35 EXTENDED N/A 45-55 30-40 CLEAR • MEASURE • SOURCE • RECEIVER • Ensure the path is CLEAR between the Source and Receiver. • MEASURE the distance between the Source and Receiver to get the best AJ Values • Start the Alignment at the SOURCE • Finalize the setup at the RECEIVER 0 4 12 AO (mA) 5 LEL•m 5,000 ppm•m (0.1 LEL•m) Methane Gas Concentration (ppm•m) Methane Gas Concentration (LEL•m) 20 www.MSAgasdetection.com Note: This bulletin contains only a general description of the products shown. While uses and performance capabilities are described, under no circumstances shall the products be used by untrained or unqualified individuals and not until the product instructions including any warnings or cautions provided have been thoroughly read and understood. Only they contain the complete and detailed information concerning proper use and care of these products. ID 0782-010-MCe / Mar 2017 © MSA 2015 Printed in U.S.A. MSA – The Safety Company 1000 Cranberry Woods Drive, Cranberry Township, PA 16066 USA Phone 724-776-8600 www.MSAsafety.com U.S. Customer Service Center Phone 1-800-MSA-2222 Fax 1-800-967-0398 MSA Canada Phone 1-800-672-2222 Fax 1-800-967-0398 MSA Mexico Phone 01 800 672 7222 Fax 52-44 2227 3943 MSA International Phone 724-776-8626 Toll Free 1-800-672-7777 Fax 724-741-1553 Email [email protected] Source Receiver 50 to 100m