Audiovox AS-9055T Installation Instructions Manual
Text of the manual
1 of 16
Kit Contents
(1) - Control Module
(2) - 1 Button High Frequency Transmitters
(1) - 1 Channel Code Learning Receiver
(1) - Multi Pin Input/Output Harness
(1) - Six Pin Power Harness
(1) - Four Pin Accessory Output (Pulse Before & After Start, During Crank & After Shut Down)
(2) - 30 Amp In-line Fuse Holders With Fuses
(1) - Control Switch
(1
2 of 16
This Remote Start System is designed for use with Automatic Transmission Vehicles Only! The unit provides wait
to start input for glow plug pre-heat which will be used for all diesel applications. If this wire is not connected, then
the unit will remain in the Gasoline mode setting, which will crank the car when the RF signal is received w
3 of 16
3
THE RECEIVER/ANTENNA ASSEMBLY:
The Superheterodyne Receiver Antenna Assembly provided with this unit allows routing from below the dashboard
for maximum operating range. Choose a location above the belt line (dashboard) of the vehicle for best reception.
Special considerations must be made for windshield glass as some newer vehicles utili
4 of 16
NOTE: This wire must be connected to the vehicle side of the starter cut relay (when used). For the electrical neutral
switch configuration, this connection must be made between the starter inhibit relay, (when used) and the
neutral safety switch as shown in the following diagram.
Failure to connect this wire to the ignition switch side of
5 of 16
VIOLET WIRE: Accessory Output
Connect this wire to the Accessory wire from the ignition switch. This wire will show + 12 volts when the ignition
switch is turned to the "ACCESSORY" or "ON" and "RUN" positions and will show 0 volts when the key is turned to the
"OFF" and "START" or "CRANK" positions.
WIRING CONNECTIONS: 12 Pin Input / Outpu
