Nikon Nivo 2.C Instruction Manual

5. Use the electronic level to level the instrument. For detailed instructions, see Leveling, page 15. 6. Look through the optical plummet to check that the image of the station point is still in the center of the reticle mark. 7. If the station point is off center, do one of the following: – If the station point is slightly off center, loosen the tripod mounting screw and then center the instrument on the tripod. Use only direct movement to center the instrument. Do not rotate it. When the instrument is centered, tighten ...

Preparation 2 C WARNING – Charge and use the rechargeable Lithium-ion battery only in strict accordance with the instructions. Charging or using the battery in unauthorized equipment can cause an explosion or fire, and can result in personal injury and/or equipment damage. To prevent injury or damage: – Do not charge or use the battery if it appears to be damaged or leaking. – Charge the Lithium-ion battery only in a product that is specified to charge it. Be sure to follow all instructions that are provided with the battery charger. ...

Preparation 2 • If the charge indicator(s) are blinking and the batteries feel cool, it may indicate a problem with the battery or the charger. If the charge light is still blinking after trying several batteries which are not warm, there is a problem with the unit or the batteries themselves. Conditioning / calibrating a battery • Battery calibration is necessary about once every 6 months or more often if desired. Calibration insures the reported battery charge remaining is accurate. • Hold down the calibration button on the unit a ...

Preparation 2 Setting the Measurement Mode and Preparing the Target The Nivo series has two measurement modes: Prism mode (Prism) and Reflectorless mode (N-Prism). These modes can be changed at any time by holding down the [MSR1] or [MSR2] key for one second. To set the measurement mode depending on the target you want to measure, see the following table. In some cases, you can measure another target that is not appropriate to the set measurement mode. Note – The Nivo2.C is Laser Class 3R in the Reflectorless mode and Laser pointer func ...

Preparation 2 Setting Up the Prism Reflector 1. Assemble the prism reflector as shown below. 2. Adjust the height of the tribrach adaptor (see page 20). 3. If necessary, change the direction of the prism (see page 20). 4. If you are using a single prism holder, set the position of the target plate (see page 20). Detailed instructions for Step 2 through Step 4 are provided on the following pages. Note – Nivo series must be used with the Tribrach W30 or W30b. Tribrach Tribrach Tripod Target plate for single prism Tiltable single prism hol ...

Unpacking and Packing the Instrument Note – Handle the Nivo series instrument gently to protect it from shocks and excessive vibration. Unpacking To unpack the instrument, grip the carrying handle and gently remove the instrument from the carrying case. Packing To pack the instrument back into the carrying case, please refer to the figure on the right. Charging the Battery Pack Before charging the battery pack, read the warnings (also listed in the Safety section at the front of this manual) and the following notes. C WARNI ...