Mercia Garden Products 01OVLPP0705SDFW-V1 General Instructions Manual

Step 11 Fix the pad bolt with 6x30mm screws to the horizontal brace on the door. Then fix the pad bolt retainer to the door panel framing using 4x30mm screws. Fix the turn buttons using 1x30mm black screw per turn button. 18 30mm screw 2x 30mm Black Screw 10x 30mm Screw Button 17 30mm screw It is ESSENTIAL that you apply wood treatment immediately after the building has been assembled. AFTER TREATMENT: score around protective cover on glazing and carefuly peel covering back ...

Step 5 Place the two roof sheets onto the bulilding, centralise them over the roof frames and ake sure front of the building. Fix in place with 40mm screws. 36x40mm Screws 8x30mm Screws Fix the eaves frame to the roof sheet using 4x30mm screws for each sheet. b b 40mm screw Pre drill hole 6 9 Step 6 b Once the roof is fixed attach the building to the floor with 50 mm screws. 18x 50mm Screws 50mm screw Pre drill hole b b b b b b b b b 90x felt tacks 1 2 Step 7 Cut the felt into 2x 2484mm long sheets and lay onto roof as show ...

Place the floor on a firm and level base, ensure the base has suitable drainage free from areas where standing water can collect. See the front page for base requirments. Step 1 5 Do not secure the building to the floor until the roof is fitted. Fix the corners with 50mm screws as shown in diagram. Position the panels so there is equal spacing between the floor and cladding on all 4 sides Step 2 2 3 3x50mm Screws Pre drill hole 50mm screw Step 3 9x50mm Screws Fix the corners with 50mm screws as shown in diagram. Pre drill ho ...

Fit the Cover Trims to the left and right of the building as shown in the illustration using 30mm screws. Trim the length of the cover trims to the required size before fitting if necessary. Pre drill to avoid splitting. 12x30mm Screws Step 8 30mm screw Pre drill hole 13 13 14 14 Step 9 10x40mm Screws Attach the faiscas to the roof leaving a slight overhang at the top. Fit the fascias to the roof over the felt and secure in place with 40mm screws as shown. Pre drill to avoid splitting. Pre drill hole 40mm screw 12 11 12 14 S ...

Step 11 Fix the pad bolt with 6x30mm screws to the horizontal brace on the door. Then fix the pad bolt retainer to the door panel framing using 4x30mm screws. Fix the turn buttons using 1x30mm black screw per turn button. 20 30mm screw 2x 30mm Black Screw 10x 30mm Screw Button 19 30mm screw It is ESSENTIAL that you apply wood treatment immediately after the building has been assembled. AFTER TREATMENT: score around protective cover on glazing and carefuly peel covering back ...

Step 12 Fix the pad bolt with 6x30mm screws to the horizontal brace on the door. Then fix the pad bolt retainer to the door panel framing using 4x30mm screws. Fix the turn buttons using 1x30mm black screw per turn button. 19 30mm screw 2x 30mm Black Screw 10x 30mm Screw Button 17 30mm screw It is ESSENTIAL that you apply wood treatment immediately after the building has been assembled. AFTER TREATMENT: score around protective cover on glazing and carefuly peel covering back ...