HID multiCLASS RMK40 Installation Manual

Flexibility is at your fingertips, use this reader simultaneously for magnetic stripe, HID Prox and high frequency smart cards. For Wiring instructions and Specifications, see the iCLASS Keypad Installation Guide (P/N 6404-901). Specifications PRODUCT PRODUCTO PRODUIT PRODUTO PRODUKT PRODOTTO 製品 产品 제품 ИЗДЕЛИЕ BASE PART NUMBER NÚMERO DE COMPONENTE BASE RÉFÉRENCE DE BASE NÚMERO DAS PEÇAS BÁSICAS HAUPTTEILENUMMER NUMERO PARTE DI BASE 基本部品番号 基本部件编号 기본부품 번호 БАЗОВЫЙ НОМЕР ИЗДЕЛИЯ INPUT VOLTAGE (VDC) TENSIÓN DE ENTRADA (VCC) TENSION D’ALIMENTATION (Vcc) VOLTAGEM DE ENTRADA (VCC) EINGANGSSPANNUNG (VDC) TENSIONE IN INGRESSO (V c.c.) 入力電圧(VDC) 输入电压 (VDC) 입력 전압(VDC) НАПРЯЖЕНИЕ ПИТАНИЯ (В постоянного тока) CURRENT CORRIENTE COURANT CORRENTE STROMSTÄRKE CORRENTE 電流 电流 전류 ТОК OPERATING TEMPERATURE TEMPERATURA DE FUNCIONAMIENTO TEMPÉRATURE DE FONCTIONNEMENT TEMPERATURA OPERACIONAL BETRIEBSTEMPERATUR TEMPERATURA D’ESERCIZIO 稼動温度 操作温度 작동 온도 РАБОЧАЯ ТЕМПЕРАТУРА CABLE LENGTH LONG. DE CABLE LONGUEUR DE CÂBLE COMPRIMENTO DO CABO COMPRIMENTO DO CABO LUNGHEZZA CAVO ケーブル長 电缆长度 케이블 길이 ДЛИНА КАБЕЛЯ UL REF NUMBER NÚMERO DE REFERENCIA UL RÉF. UL NÚMERO DE REFERÊNCIA UL UL-REFERENZNUMMER NUMERO DI RIFERIMENTO UL UL参照番号 UL 参考编号 UL 참조 번호 Справочный номер в UL AVG PEAK RMK40 6230 5-16 VDC 85 mA 120 mA -30° - 150°F (-35° - 65° C) Wiegand = 500 ft - 22 AWG (152.4 m) 300 ft - 24 AWG (91.44 m) RMPK40Cx1x2N RMPK40 6236 ** 85 mA 169 mA UL Reference Number Deciphering x1 Reader Colors: K = Black, G = Gray x2 multiCLASS Proximity: N = HID/AWID Prox multiCLASS Models: RMK40 / RMPk40 Installation Guide 6410-901, Rev A.1 August 18, 2009 © 2009 HID Global Corporation. All rights reserved. 15370 Barranca Parkway Irvine, CA 92618-2215 USA

6410-901 A.1 INSTALLATION GUIDE 2 ©2009 HID Global Corporation. All rights reserved. 1 Head Track Adjustments For a credential with a different track position, change the head track position on the Magnetic Stripe reader. Snap out the head/gimbal assembly. 1. Rotate the assembly 180 degrees. 2. Re-install the assembly into the reader case. 3. 2 Mounting Junction box not included. Caja para conexiones no incluida. Boîtier de jonction non inclus. Caixa de junção não incluída. Anschlusskasten nicht mit inbegriffen. Scatola di raccordo non inclusa. 不包括接线盒。 接続ボックスは含まれていません。 연결 박스는 제품에 포함되지 않습니다. Соединительная коробка не прилагается Wires away from reader face Wires toward reader face (default)

multiCLASS RMK40 / RMPK40 4 Install Reader to Backplate 3 Wiring Attach wire (see step 2) from the magnetic stripe reader to the iCLASS Keypad reader connector. Connector Module

Irvine, CA 92618 USA Phone: 800 237 7769 Support: 866 607 7339 Fax: 949 732 2120 Email: [email protected] Asia Pacific 19/F 625 King’s Road NorthPoint, Island East Hong Kong Phone: 852 3160 9800 Support: 852 3160 9833 Fax: 852 3160 4809 Email: [email protected] Europe, Middle East & Africa Phoenix Road Haverhill, Suffolk CB9 7AE England Phone: +44 1440 714 850 Support: +44 1440 711 822 Fax: +44 1440 714 840 Email: [email protected] HID Global 6410-901 Rev A.1 Patent Pending © 2009 HID Global Corporation. All rights reserved. Check reader label for current regulatory approvals. HID, HID Global, and iCLASS are the trademarks or registered trademarks of HID Global Corporation in the U.S. and other countries. UL Connect only to a Listed Access Control / Burglary power-limited power supply. These readers are intended to be used with listed (UL294) control equipment. Only the Wiegand communication protocol has been investigated by UL. FCC / Canada Radio Certification These devices comply with part 15 of the FCC rules. Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. Le fonctionnement est soumis aux deux conditions suivantes : (1) Ce dispositif ne peut pas causer de perturbations nuisibles et (2) ce dispositif doit accepter toute perturbation quelconque qu’il reçoit, y compris des perturbations susceptibles de provoquer un fonctionnement indésirable. Les changements ou modifications n’ayant pas été expressément approuvés par la partie responsable de la conformité peuvent faire perdre à l’utilisateur l’autorisation de faire fonctionner le matériel. CE Marking HID Global hereby declares that these proximity readers are in compliance with the essential requirements and other relevant provisions of Directive 1999/5/EC. Por el presente, HID Global declara que estos lectores de proximidad cumplen con los requisitos esenciales y otras disposiciones relevantes de la Directiva 1999/5/EC. HID Global déclare par la présente que ces lecteurs à proximité sont conformes aux exigences essentielles et aux autres stipulations pertinentes de la Directive 1999/5/CE. A HID Global, por meio deste, declara que estes leitores de proximidade estão em conformidade com as exigências essenciais e outras condições da diretiva 1999/5/EC. HID Global bestätigt hiermit, dass die Leser die wesentlichen Anforderungen und anderen relevanten Bestimmungen der Richtlinie 1999/5/EG erfüllen. HID Global dichiara che i lettori di prossimità sono conformi ai requisiti essenziali e ad altre misure rilevanti come previsto dalla Direttiva europea 1999/5/EC. Download copies of the R&TTE Declaration of Conformity (DoC) at http://certifications.hidglobal.com.