JAGER PRO M.I.N.E. Operation Manual

this position. Secure the rod adapter with pliers. Turn the set screw with a 3/32 Allen wrench to break the Loctite® seal at threads. Place the rod adapter through the latch arm. Guide the connecting rod through the rod adapter while sliding the control box into place. See “Attaching Connecting Rod to Latch” on next page before tightening rod adapter. Ensure the control box is tight against the trigger assembly. Using a 3/8” nut driver and drill, secure the control box to the frame with four #14 self tapping, 3/4” long screws. ...

safety procedures that must be understood BEFORE assembling or using the M.I.N.E.™ Trapping System. Failure to review and understand the ENTIRE MANUAL prior to assembly or use could result in serious injury or death to you or someone else. CRUSH HAZARD: This device uses a wireless transmitter to remotely trigger a HEAVY DROP GATE, which can cause serious injury or death. ALWAYS secure the drop gate with the Gate Safety Clip before conducting any work on or around the gate. ALWAYS ensure that gate area is clear BEFORE pus ...

Equipment Inventory and Identification ....................................................4 Installation Tools and Supplies.......................................................................5 Material List of Equipment Not Included ..................................................6 Adjusting Trigger Assembly .....................................................................7 Installing Connecting Rod and Clevis ......................................................8 Installing Control ...

until the trigger square stock is sitting on the outside edge of the trip arm. Then tighten the trigger assembly nuts with a 9/16” wrench. Lightly tighten the bolt and nut on the trip arm using a 1/2” wrench and socket so the trip arm stays in the “up” position without falling, but can still easily move. Work the trip arm up and down onto the latch to ensure there is no binding. It is important the trip arm stays in the “up” position without falling. This step allows the use of both hands to raise the gate. Loosen the trigger assembly ...

with a hand pick to conceal the bottom gate frame (A). Use a level to ensure the drop gate remains square for smooth operation. Cover the threshold with dirt and camouflage to blend with surrounding area (B). The panel joint at the gate support post is the weakest link if not secured properly. Ensure the panel’s vertical 1/4” steel rods are on the outside of the enclosure (against the post) and the horizontal steel rods are on the inside. Use the post lugs to lock the vertical steel rod between the post and gate s ...

clevis to this position. Work the rod back & forth to ensure there is no binding. Never transport the M.I.N.E.™ Gate with battery inside the control box or severe damage to electronics and battery will occur. Remove battery during transport and always disconnect when not in use. Push the 1/8” connecting rod through the plastic clevis. Slide the connecting rod through the actuator hole inside the control box. Align the slots and gently snap the clevis onto the actuator arm. ...