IBM Aptiva Handbook

Identifying the parts of the system unit ..................................................................................... 79 Adding and removing adapter cards ......................................................................................... 81 Identifying adapter card connectors ..................................................................................... 81 Identifying card cable connectors ............................................................ ...

When the computer is turned on, a picture appears indicating a diskette should be inserted into drive A. 1. Choose Startup Options from the Setup Utility Main Menu, and make sure that startup devices are set correctly. 2. Make sure the drive power and signal cables are securely attached to the back of the hard disk drive. For instructions on working in the desktop system unit, see “Adding and removing drives” on page 86. For instructions on working in the minitower system unit, see “Adding and removing drives” on page 108. 3. ...

Installing a drive in bay 3 Bay 3 holds a 3.5-inch slim hard disk. Before beginning these steps, you must remove any drives installed in bays 1 and 2. For instructions on removing a drive from bay 1, see “Installing a drive in bay 1” on page 91. For instructions on removing a drive from bay 2, see “Installing a drive in bay 2” on page 93. 1. Right bracket removal Remove the screws and disconnect any drive cables. (Notice how the cables are attached. You may need to reconnect these cables when you are finished.) Slide the right ...

80MB 8MB 8MB 32MB 32MB 80MB 16MB 32MB 32MB 96MB 32MB 32MB 16MB 16MB 96MB 16MB 16MB 32MB 32MB 96MB 32MB 32MB 32MB 128MB 32MB 32MB 32MB 32MB Table 8: Memory module placement (Continued) Total memory Socket 1 Socket 2 Socket 3 Socket 4 ...