SecureALL SA-ROU Installation Manual

Page 2 of 7 All Rights Reserved SecureALL Corporation SA-ROU Installation Guide Copyright © 2013 by SecureALL Corporation. All rights reserved under International and Pan-American copyright conventions. No part of this document may be reproduced in any form or any means, electronic or mechanical, including photocopying, without permission in writing from the Company. All inquiries should be addressed to SecureALL Corporation, 695 Woburn Court, Mountain View, CA 94040.

Page 3 of 7 All Rights Reserved Revision History Version Date Author Revision Description 1.0 08-10-2013 RAS Initial version

Page 4 of 7 All Rights Reserved Table of Contents Revision(History(................................................................................................................(3( Table(of(Contents(..............................................................................................................(4( Introduction(.......................................................................................................................(5( Installation(Instructions(................................................................................................(5( (

Page 5 of 7 All Rights Reserved I. Introduction These instructions are to be used to install a SecureALL SA-ROU router. Customer Supplied Materials: 1. Phillips head screwdriver 2. 1/2" 8-32 screws (2) 3. Carlon B618R 4O Box 4. CAT-5 cable, one end of which is connected to a POE switch II. Installation Instructions 1. Based on the router installation drawings supplied by SecureALL, locate the position at which a router is to be installed. Drill a 4 1/8" hole in the ceiling tile. 2. Procure a Carlon B618R 4O box (available at Home Depot). Pictures are shown below. Figure 1a Figure 1b 3. Screw the 8-32 screws into the 4O box, leaving approximately 1/16". Remove one of the breakout sections (Fig. 1b). This is where the CAT-5 cable will be threaded through the box. 4. Pull the CAT-5 cable through the hole in the ceiling tile and then thread it through the 4O box opening (Fig 2). Figure 2 8-32 screws Breakout section

Page 6 of 7 All Rights Reserved 5. The 4O box comes with wings (Fig. 3a). Fold the wings back and insert the box into the hole in the ceiling tile (Fig. 3b). Figure 3a Figure 3b 6. Screw the three screws connected to the wings until the box is securely in the ceiling tile. 7. The router dome is shown in Fig 4a (bottom view) and Fig 4b (side view). Note in Fig 4a the CAT-5 cable socket and the holes that are used to attach the router to the 4O box. Figure 4a Figure 4b 8. Take the CAT-5 cable that has been threaded through the 4O box and plug it into the router socket (Fig 5.) Figure 5 Wing screws Connecting holes CAT-5 socket

Page 7 of 7 All Rights Reserved 9. There is a small switch (Fig. 6) just to the left and below the CAT-5 socket in the router. Check to make sure the switch is to the right, in the "normal" position. Figure 6 10. Holding the router by its dome, align the connecting holes with the 8-32 screws in the 4O box. Slide the router onto the screws and rotate the dome until the router is securely in place. If the router has difficulty going onto the screws, loosen the screws slightly and re-attach. If the router is too loose after attachment, tighten the screws slightly and re- attach. (See Fig. 7 for final assembly) Figure 7 Switch