Vertiv GEIST SwitchAir SA2-006 Quick Installation Manual

Quick Installation Guide VM1181/590-2245-501A 1 RACK FRONT RACK REAR Models: SA2-006 Switch Type: Side Intake - Side or Rear Exhaust for Core Switches CAUTION: Ensure the required airflow for safe operation of equipment is not compromised when installing the Geist SwitchAir device. WARNING: Take precaution to avoid interference with the switch’s input power cords when installing behind a live switch. 1. Installing the support channel Insert the six customer-provided cage nuts into the four holes on the front of the support channel and two holes into the rear channel extension tab. Insert the extension tab into the rear of the support channel. With the channel facing the centerline of the rack, hold the support channel on the inside of the left rack uprights in the 2U space just above the network switch. Using customer- provided screws, attach the channel to the front rack upright only in the top and bottom holes of the 2U space. Adjust the extension tab to the proper length and attach the extension tab onto the rear upright with two screws. 2. Installing the air channel Insert the four customer- provided cage nuts into the four holes on the front of the air channel. In the 2U space opposite the support channel, hold the air channel on the inside of the right rack upright. Orient the air channel to face the centerline of the rack with its open leg facing Geist SwitchAir Airflow Management Device Support and Air Channels Installation 1 CENTERLINE OF RACK 2 Extension tab Support channel Left rack upright Right rack upright Network switch Air channel Cage nuts Cage nuts Cage nuts

© 2019 Vertiv Co. All rights reserved. Vertiv and the Vertiv logo are trademarks or registered trademarks of Vertiv Co. All other names and logos referred to are trade names, trademarks or registered trademarks of their respective owners. While every precaution has been taken to ensure accuracy and completeness herein, Vertiv Co. assumes no responsibility, and disclaims all liability, for damages resulting from use of this information or for any errors or omissions. Specifications are subject to change without notice. GEIST™ SWITCHAIR AIRFLOW MANAGEMENT DEVICE Quick Installation Guide 2 VM1181/590-2245-501A RACK FRONT RACK REAR down. Fasten in place using screws only in the top and bottom holes of the 2U space. 3. Installing the SwitchAir device into the rack NOTE: Connect to power before attaching the SwitchAir device to the rack. (The SwitchAir device has a standard C14 power inlet. Due to the variety of possible power source outlet types, an appropriate power cord must be determined and supplied by the customer.) Insert the SwitchAir device into the support and air channels. Using four customer-provided screws, attach the device to the rack. Geist SwitchAir Device Installation Support channel Air channel SwitchAir device Airflow Airflow Geist SwitchAir Device Airflow Directions 3