GREISINGER GMH 2710-T Operating Manual

page 7 of 8 _____________________________________________________ _____________________________________________________________________________ 10 Error and System Messages ERR. 1 Value exceeding measuring range, value too high or cable/sensor broken ERR. 2 Value exceeding measuring range, value too low or cable/sensor shorted ERR. 7 System error – the device has detected a system error (device defective or not within working temperature) The blinking bAt display indicates low battery voltage, device will continue to work for a sh ...

page 3 of 8 _____________________________________________________ _____________________________________________________________________________ 3 Safety Requirements This device has been designed and tested in accordance with the safety regulations for electronic devices. However, its trouble-free operation and reliability cannot be guaranteed unless the standard safety measures and special safety advises given in this manual will be adhered to when using the device. 1. Trouble-free operation and reliability of the device can only be guaranteed i ...

page 4 of 8 _____________________________________________________ _____________________________________________________________________________ 4.3 Pop-up clip Handling: • Pull at label “open” in order to swing open the pop-up clip. • Pull at label “open” again to swing open the pop-up clip further. Pop-up clip closed Pop-up clip at position 90° Pop-up clip at position 180° Function: • The device with a closed pop-up clip can be plainly laid onto a table or attached to a belt, etc. • The device with pop-up clip at position 90� ...

page 7 of 8 _____________________________________________________ _____________________________________________________________________________ 10 Error and System Messages ERR. 1 Value exceeding measuring range, value too high or cable/sensor broken ERR. 2 Value exceeding measuring range, value too low or cable/sensor shorted ERR. 7 System error – the device has detected a system error (device defective or not within working temperature) The blinking bAt display indicates low battery voltage, device will continue to work for a sh ...

Seite 7 von 8 _____________________________________________________ _____________________________________________________________________________ 10 Fehler- und Systemmeldungen ERR. 1 der Messbereich ist überschritten, Messwert ist zu hoch oder Fühler- bzw. Kabelbruch ERR. 2 der Messbereich ist unterschritten, Messwert ist zu tief o. Fühler- bzw. Kabel kurzgeschossen ERR. 7 Systemfehler - das Gerät hat einen Systemfehler erkannt (Gerät defekt oder weit außerhalb zulässiger Arbeitstemperatur) Batteriespannung schwach, Funktion is ...

Seite 8 von 8 _____________________________________________________ _____________________________________________________________________________ EMV: Das Gerät entspricht den wesentlichen Schutzanforderungen, die in der Richtlinie des Rates zur Angleichung der Rechtsvorschriften der Mitgliedsstaaten über die elektromagnetische Verträglichkeit (2004/108/EG) festgelegt sind. Zusätzlicher Fehler: <1 % ...

page 5 of 8 _____________________________________________________ _____________________________________________________________________________ 6 Basics Probe Precision/Device Precision The device has a very good system accuracy (please refer to technical data). This is due to the calibration of the probe acc. To the connected instrument plus the use of precise measurement electronics and premium Pt1000 sensor elements Heat loss caused by probe construction: Especially when measuring temperatures which deviate very much from the ambient temperatu ...