Forms + Surfaces Knight Bollard Installation Instructions

page 1 of 2 | Rev. 08-16-16 © 2016 Forms+Surfaces® | All dimensions are nominal. Specifications and pricing subject to change without notice. For the most current version of this document, please refer to our website at www.forms-surfaces.com. T 800.451.0410 | www.forms-surfaces.com TOOLS NEEDED MATERIALS INCLUDED STEP BY STEP Create space for footer • A sufficient footer size depends on frost and other conditions to be determined by the installer. A minimum of an 18" x 18" wide x 30" deep footer is recommended. Position and support security core • Position security core in desired final location and support so concrete can be poured in hole around security core. • The bottom of the base plate should be level with the ground surface. NOTE: The security core also serves as a conduit path. Pour concrete footer • Mix concrete and pour footer according to concrete manufacturer’s instructions. • As soon as footer is poured, verify levelness. • Allow concrete to cure completely according to concrete manufacturer’s instructions before removing any temporary supports or installing fixture. NOTE: Security core will need to be free of moisture prior to fixture installation. FOR ALL KNIGHT SECURITY BOLLARDS a 5/32" hex bit WIDTH DEPTH BOTTOM OF BASE PLATE AT GROUND LEVEL level

page 2 of 2 | Rev. 08-16-16 © 2016 Forms+Surfaces® | All dimensions are nominal. Specifications and pricing subject to change without notice. For the most current version of this document, please refer to our website at www.forms-surfaces.com. T 800.451.0410 | www.forms-surfaces.com Position bollard over security core • Inspect security core for moisture. If moisture is present remove and dry immediately before installing fixture. Do not install fixture unless security core is completely dry. • Slide bollard over security core so lower holes in bollard line up with holes in security core base plate. STEP BY STEP FOR ALL KNIGHT SECURITY BOLLARDS Attach bollard to security core • Thread 1/4"-20 x 3/4" flat head cap screw (a) into each lower hole in bollard. • Use 5/32" hex bit or key to tighten all screws until snug. a a a