ARC FEATHER Operation & User’s Manual

28 TROUBLESHOOTING TABLE Issue Solution Display won’t turn on Check all connections from the motor controller to the handlebars starting with the plug coming from the display. Ensure that the battery is switched on. Display turns on, the motor doesn’t start Check the motor plug from the controller. Ensure that this plug is aligned correctly and seated very firmly. A high pitched rattling noise can be heard when accelerating Vibration from the motor is small, though it may be enough for you to hear a loose component near the motor. Check all fasteners ...

20 To mount the PAS, apply a single zip tie around the top section of the PAS unit. This will allow you to partially test operation before mounting it more permanently. The sensor should be no further than 5mm away from the magnet wheel and not have a large angle. ASSEMBLY—PEDAL ASSISTANCE Now that the PAS is fitted, when the system is turned on the and the pedals are turned, the motor will activate. You will notice that the light on the PAS will flash when the system is operating. If this is not flashing you may need to adjust the sensor’s location/ ...

8 This section will detail some of the basic steps you should undertake to prepare your bicycle for conversion. ASSEMBLY—BICYCLE PREPERATION The first thing you should do is find a suitable space in which to conduct the installation. If you don’t have a nice soft surface to flip the bike over onto, or don’t have a bike maintenance stand, then we recommend using some of the foam packaging in the kit to prevent any unintended damage to your bike. As in the photographs above, flip the bike over in preparation for removing the front wheel motor mountin ...

22 This section will detail the operation of the bike post-conversion. To activate the motor, ensure that the battery is connected and the throttle button has been switched on. The motor can now be actuated through pedalling or utilising the throttle. OPERATION Charging the battery is a simple process and can be completed with the battery mounted to the bicycle or when the battery has been removed from the electric bike. OPERATION—BATTERY CHARGING Follow the following steps: • Plug the charger into the wall socket and turn the socket on. • Locate t ...

23 This section will detail exactly what a battery is, its features and how to maintain good battery health over the course of its lifetime. The battery should be charged once every month as a minimum to maintain healthy cells. The best way to charge your battery is to plug it in after every use, and leave it on charge until the indicator light shows the battery is fully charged. It is not good practice to only half or partially charge the battery. The smart battery charger will ensure that the cells are charged to maximum capacity, without overcharging ...

3 TABLE OF CONTENTS EBike Components and Terminology ........................................................ 4 Assembly .................................................................................................. 6 Unboxing ........................................................................................... 6 Inventory ........................................................................................... 7 Bicycle Preparation ........................................................................... 8 Motor .......................... ...

11 Now to mount the motor into the front forks. ASSEMBLY—FRONT MOTOR Familiarise yourself with the washers and their positions. Ensure that the torque washers (which are the washers with a notch) are both on the same way on the axle. Line the torque washers up with the axle slots. As you can see in the photograph on the right, the torque washer will not fit in the axle slot with the current washer configuration. We will need to remove the internal washer from the setup so that the torque washer is the only washer present on that side. This section is d ...