Borg & Overstrom b4 Quick Start Manual

GB Ambient Chilled Dispense Options Chilled & Ambient Chilled & Hot Chilled & Sparkling Chilled, Hot & Sparkling Description Major Components Water & CO2 Connection CO2 Bottle Installation Level Sensor Assembly Cold Water Connection & Operation Functions & Controls General Safety Isolation & Removal Sanitisation Guide Leak Detectio ...

GB 2 Installation Major Components Water & CO2 Connection Carbonation Switch On/Off Switch IEC Power Socket CO2 Connector (1/4”) Inlet Water (1/4”) Drain Port Quick Start Guide Cold Water Tank Sparkling Water Tank Lid Control Panel Hot Water Tank © Copyright Borg & Overström. This manual is printed by Borg & Overström and shall not b ...

Borg & Overström GB 3 CO2 Bottle Installation (Sparkling Versions Only) IMPORTANT! ALWAYS ENSURE SECURITY CLIPS ARE USED ON ALL WATER AND CO2 CONNECTIONS. OFF 1 Attach the regulator to the disposable CO2 bottle, ensuring the regulator is closed. Connect the CO2 bottle and regulator to the machine using 1/4 inch pipe. COLD 2 After completin ...

Borg & Overström GB 4 Level Sensor Assembly (floor standing unit only) Unpack all contents. 1 PANASONIC CR 2032 3V PANASONIC CR 2032 3V Unscrew lid, fit both batteries and refit lid. 2 Exchange the drip tray. 3 Connect the drainage tubing that is pre-fitted down the front left hand side of the cabinet. 4 ...

GB 5 Operation Quick Start Guide Water Connection & Operation Connect and turn on the water supply. Then connect the power supply ( N.B. sparkling variants will fill automatically). 1 All hot & non-sparkling cold tanks must be purged of air by holding the corresponding button. 2 COLD On sparkling models turn on the carbonation switch on the ...

Borg & Overström GB 6 Flush through 10 litres of water before use. 5 10 L When the cold water switch is turned on, the cold water and chilling LED will be on. hot cold sparkling chilling heating 6 COLD Allow up to 1 hour for the water to reach its minimum temperature. 7 1 hour The temperature of cold water can be set from 4c to 10c. When t ...

Borg & Overström GB 7 Functions & Controls hot cold sparkling chilling heating General Safety 15cm • Leave a space no less than 15cm between the wall and dispenser. • Keep the machine away from sunlight, heat and moisture. Chilled Water Button Sparkling Water Button Hot Water Button Hot Water Lock Button Ambient Water Button (selected ...

GB 8 Maintenance & Cleaning 1 Please make sure the machine is completely disconnected from electricity before carrying out any maintenance work. 2 Turn off the water supply. 3 To drain the Direct Chill tank, remove the cap on the back of the machine. We recommend it is refitted immediately upon draining being completed. Cold water drain Qui ...

Borg & Overström GB 9 Sanitisation Guide NOTE: Before beginning the sanitation process please ensure that water is turned off at the mains and refer to the MSDS document for further information. Use bioguard hand gel and ensure gloves are worn. cold chilling 1 Briefly press cold/ambient dispense button to release internal water pressure fr ...

Borg & Overström GB 10 Sanitisation Guide (continued) 5 Remember to include the drip tray. If a Waste Overflow System is fitted, empty this and flush through with a small amount of sanitisation fluid if needed. 6 When the external cleaning (minimum 5 minutes) is completed, flush the machine using the cold button with clean water until the ...