Air Hogs Jetscream Instructions

Charging LED Left/Right Toggle Power LED Check to make sure contents are complete: • 1 Air Hogs® Jet Scream™ • 1 Charger/Controller • 1 Instruction Sheet Experience radio-controlled flight with the Air Hogs® Jet Scream™! The Jet Scream™ makes flying fun & easy! Just choose the direction you want to fly and move the controller toggle. The ultra-light Jet Scream™ is powered by a lithium battery for long flights, features precision speed control and damage-resistant foam. The Jet Scream™ also includes an integrated Charger/Controller unit for convenient portability and easy handling on the field. Perfect for both indoor and outdoor flights. 1. Use a Phillips screwdriver to loosen the battery door. 2. Slide the battery door towards the bottom of the unit and remove. Install six AA 1.5-V alkaline batteries (not included). Be careful to align the positive (+) and negative (-) polarities with the corresponding markings inside the battery compartment as shown. 3. Reinstall the battery compartment door and re-tighten the hold down screw. 2 1 Charger/Controller Battery Compartment Door Six AA 1.5-V Alkaline Batteries IMPORTANT TIP: TURN YOUR CONTROLLER ON TO ENSURE THAT THE BATTERIES ARE INSTALLED PROPERLY. THE RED LIGHT ON THE FRONT OF THE CONTROLLER SHOULD TURN RED. Your Jet Scream™ jet has preinstalled rechargeable batteries in the jet’s fuselage. Because the Controller’s AA batteries are used for 2 functions – charging and controlling, they will need to be replaced after every 20 – 25 flights. After each flight, store the jet in the package to prevent damage. REPAIRS CHARGER/CONTROLLER BATTERY INSTALLATION If the wings on your jet get damaged they can be easily repaired with clear tape as shown. INSTRUCTIONS ® TM Ducted Fan Engine Fuselage Canard Ducted Fan Main Wing CARE AROUND DUCTED FAN ENGINES Ensure the Fans can spin freely. You may use a toothpick or tweezers to clear debris out of the Ducted Fan engines. Never stick your finger into the path of the fan blades. CAUTION: Never place fingers or hair in or near Ducted Fan engines. Never run Ducted Fans when examining Fan Engines, as debris from grass or dust may get in your eyes and cause injury. IMPORTANT – Adult Supervision is Recommended. Problems flying? Do not return your Air Hogs® to the store. Call the Air Hogs® flight training center at 1-800-622-8339 Antenna Channel Switch Repair

CHARGING YOUR JET 1. Push the ON/OFF switch to the LEFT to turn the jet OFF. 2. Flip the charge door open to reveal the charge nozzle. 4. Set the Charge/OFF/ ON switch to the left CHARGE position. 3. Push the charge nozzle all the way into the jet’s charge port located on the bottom of the jet. 1 4 3 2 FLYING INSTRUCTIONS 1. Fully extend the controller antenna. 3. The Red LED light will glow solid. 4. Push the jet’s ON/OFF switch to the ON position to start the engine. 2. Set the Charge/OFF/ON switch to the ON position. 5 5. During the charging process, the green LED will blink. When the jet is fully charged the light will switch to a steady GREEN. 6. Remove charge nozzle gently from the jet’s charge port. FLYING INDOORS? NOTE: Always get a parent’s permission to fly your Jet Scream™ indoors. Location – Fly in a wide open room, far from breakable items – an empty double car garage or unfinished basement are great options. Avoid flying near vents and/or fans, as they may overpower the jet and make it difficult to control. 5. When launching the jet, use partial throttle. Refrain from using the directional toggle while launching the jet. Launch the jet against the wind and parallel to the ground. When preparing for take off, check the direction of the wind. Always launch your jet against the wind for the best take off and flight results. TIP: The wind will blow against your face, if you are facing the correct direction. Important Charging Information: • Before taking your initial flight, charge the jet for a complete charge cycle on your charger. • Depending upon the length of future play, you will not need to complete a full charge before each flight. NOTE: A shortened charge results in a shorter playtime (may take up to 1/2 hour to fully charge). Green LED 6 7. Store the charge nozzle and close the charge door. 7 1. Location – Fly in a large wide open, grassy location that is free of buildings, trees, overhead wires, and other obstructions. Do not fly near people or animals. 2. Weather – Fly on mild, sunny days. Do not fly in electrical storms, rain, sleet, snow or other adverse weather conditions. Do not fly if the temperature is below 45°F. In very cold temperatures, the jet will become fragile and the engine performance will decrease. 3. Wind Conditions – Do not fly in wind. Winds may overpower the jet and make it difficult to control. In windy conditions, it may appear as though you have no control over the jet. Holes in plug must align with pins in jet.

Charger/ON/OFF to OFF by pushing the switch to the left. ONCE THE JET HAS LANDED LEFT TURN Move the direction toggle LEFT. To make the jet climb, ease the throttle forward. Too much throttle can cause a stall. TO LAND Select a soft grassy area, and pull the THROTTLE down. To ACCELERATE upwards Push the throttle further UP. RIGHT TURN Move the directional toggle RIGHT. CONTROLLING JET FLIGHT 2. Turn the jet OFF by pushing the switch to the left position. 1. If you want to straighten out your flight path, adjust by turning the Steering Trim Knob to the left or right during flight. FLIGHT ADJUSTMENTS 2. Check which letter is on the underside of the jet. Move the channel switch to the corresponding letter to get power.

PROBLEM Jet will not start or has low power. Jet will not turn. Jet is flying too low. Jet is flying too high. Motors don’t stop when Controller is turned OFF. CAUSE 1. Jet not charged. 2. Battery power is drained. 3. Jet was not set to OFF during charging. 4. Charger/Controller was not set to “Charger OFF”. 1. Control is not ON. 2. Controller antenna is not extended. 3. It’s a windy day or you’re flying by a vent/fan. 1. Needs more power. 2. The six AA batteries in the Charger/Controller are drained. 1. Need to decrease power. 1. Set to full throttle. SOLUTION 1. Charge jet for a complete charge cycle. 2. Replace the Charger/Controller batteries after 20 flights. 3. The jet won’t accept a charge in the ON position. Always set to “OFF” before charging. 4. The Charger/Controller will NOT charge in the “Control ON” position. Always set the Charger/Controller to “OFF” before attempting to charge. 1. Set Controller to “Controller ON” 2. Fully extend Controller antenna before flying. 3. Do not fly in winds. Windy conditions will limit and prevent your ability to control the jet. If flying indoors, do not fly near a vent/fan. 1. Push the Throttle UP. 2. Install new batteries. 1. Pull the Toggle DOWN. 1. Turn Controller ON, reduce throttle to 0 and turn Controller OFF. Battery installation should be performed by an adult. Use only batteries recommended in the instruction sheet. Be careful to install the batteries with the correct polarity, as indicated. • Do not mix old and new batteries. • Do not mix alkaline, standard or rechargeable batteries. • Battery installation should be done by an adult. • Non-rechargeable batteries are not to be recharged. • Rechargeable batteries are to be removed from the toy before being charged (if removable). • Rechargeable batteries are only to be charged under adult supervision (if removable). • Only batteries of the same or equivalent type as recommended are to be used. • Batteries are to be inserted with the correct polarity. • Exhausted batteries are to be removed from the toy. • The supply terminals are not to be short-circuited. • Different types of batteries, or new and used batteries are not to be mixed. • Exhausted batteries are to be removed, as they will adversely affect the performance. REQUIRED BATTERIES: Charger/Controller takes 6 AA Alkaline Batteries (not included). This device compiles with part 15 of the FCC rules. Operation is subject to the following two conditions: 1. This device may not cause harmful interference, and 2. This device must accept any interference received, including interference that may cause undesired operation. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of more of the following measures: • Reorient or relocate the receiving antenna. • Increase the separation between the equipment and the receiver. • Connect the equipment into an outlet on a circuit different from that to which the receiver is needed. • Consult the dealer or an experienced radio/TV technician for help. FCC STATEMENTS: Contains Lithium Polymer battery. Battery must be recycled or disposed of properly. Spin Master Ltd., 450 Front Street West, Toronto, ON M5V 1B6 Canada Spin Master, Inc., PMB #10053, 300 International Drive, Suite 100, Williamsville, NY 14221, USA Spin Master Toys Far East Limited, Rm #1113, 11/F, Chinachem Golden Plaza, 77 Mody Rd., Tsimshatsui E., Kowloon, HK North American Consumer Information Phone: 1-800-622-8339 www.spinmaster.com Air Hogs ® is a registered trademark and Jet Scream TM is a trademark of Spin Master Ltd. © 2007 Spin Master Ltd. All rights reserved. Manufactured for and distributed by Spin Master Ltd. Conforms to safety standards ASTM F963, EN71 Regulatory Requirements. Products and colors may vary. Please retain this information for future reference. MADE IN CHINA. #20007663 NEN REV 1 TM Your jet is equipped with a Lithium Polymer battery; please also pay attention to the following cautions for safe use: • Do not dispose the battery in fire or heat. • Do not use or leave the battery near a heat source such as fire or heater. • Do not strike or throw the battery against hard surfaces. • Do not immerse the battery in water. Keep the battery in a cool dry environment. • When charging, only use the battery charger specifically for that purpose. • Do not over-charge the battery. • Do not connect the battery to an electrical outlet. • Do not directly solder the battery or pierce the battery with a nail or other sharp objects. • Do not transport or store the battery together with metal objects such as necklaces, hairpins, etc. • Do not disassemble or alter the battery. • Charge the battery every 6 months. • Turn off your equipment power switch after use. • As for a used battery, please recycle the battery by covering the terminals with insulation tape or inserting into an individual polybag. CAUTION: PLEASE READ BEFORE CHARGING OR USING BATTERY. CAUTION: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.