Code 3 CC2030-WC Operating Instructions

Failure to install or use this product according to manufacturer’s recommendations may result in property damage, serious bodily/personal injury, and/or death to you and those you are seeking to protect! ! WARNING! 1. Proper installation combined with operator training in the use, care, and maintenance of safety products are essential to ensure the safety of you and those you are trying to protect. 2. Exercise caution when working with live electrical connections. 3. This product must be properly grounded. Inadequate grounding and/or shorting of electrical connections can cause high current arcing, which can cause personal injury and/or severe vehicle damage, including fire. 4. Proper placement and installation are vital to the performance of this safety product. Install this product so that the performance of the system is maximized and the controls are placed within convenient reach of the operator so that s/he can operate the system without losing eye contact with the roadway. 5. It is the responsibility of the vehicle operator to ensure during use that all features of this product work correctly. In use, the vehicle operator should ensure the field-of-view of the camera/monitor is not blocked by vehicle components (i.e., open trunks or compartment doors), people, vehicles, or other obstructions. 6. Never take the right-of-way for granted. It is your responsibility to be sure you can proceed safely before entering an intersection, driving against traffic, responding at a high rate of speed, walking on or around traffic lanes. 7. This equipment is intended for use by authorized personnel only. The user is responsible for understanding and obeying all laws regarding safety products. Therefore, the user should check all applicable city, state, and federal laws and regulations. The manufacturer assumes no liability for any loss resulting from the use of this safety product. Do not install and/or operate this safety product unless you have read and understand the safety information contained Specifications: Battery Capacity 3.6V/6700mAh Charging Voltage DC 5-12V Charging Time 5V/8 hrs, 12V/3hrs Discharging Time 12 continuous hours Charging Temperature -10 TO 45°C Waterproof Rating IP69K Image Device 1/3” CMOS PC3089 TV System PAL, NTSC Effective Pixels 756 x 504 Pixels Sensing Area 4.80mm x 3.73mm Scanning System 2:1 Interlace Sync System Internal Operation Frequency 2400-2483.5 MHz Line of Sight Range 120m Delay 120 m/s Night Vision Distance 8 to 10 meters Audio Yes Viewing Angle 120° IR-Cut Yes Standby Mode 30 seconds of inactivity Magnetic Strength 60 lbs Using the CC7008-WM monitor: 1. Press S to enter the single image mode and image number to be paired. 2. Press M to enter the Menu. 3. Use the + or - to highlight the PAIRING Option. 4. Press the down arrow to enter the PAIRING Option. 5. The monitor will display the message “PAIRING START 50” and a counter that counts down 50 seconds. Power on the camera within the first 45 seconds. 6. The camera will pair with the monitor after 5-8 seconds. Using CC7008-WM remote: 1. Press SEL to enter the single image mode and image number to be paired. 2. Press PAIR to enter the PAIRING OPTION. 3. The monitor will display the message “PAIRING START 50” and a counter that counts down 50 seconds. Power on the camera within the first 45 seconds. 4. The camera will pair with the monitor after 5-8 seconds. 0%-25% 25%-50% 50%-75% 25%-50% ON/OFF FIGURE 1 Pairing Instructions: Operating Instructions CC2030-WC Wireless Camera all-guide s.com

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference. (2) This device must accept any interference received, including interference that may cause undesired operation. Declaration of conformity: 920-0681-00 Rev. A Description Part Number Wall Charger Replacement CW4002-NA Metal Plate with High Bond Tape EZ2000HBT Accessory and Replacement Parts: 10986 North Warson Road St. Louis, MO 63114 Technical Service (314) 996-2800 [email protected] www.code3esg.com An ECCO SAFETY GROUP™ Company www.eccosafetygroup.com Manufacturer Limited Warranty and Limitation of Liability: Manufacturer warrants that on the date of purchase this product will conform to Manufacturer’s specifications for this product (which are available from the Manufacturer upon request). This Limited Warranty extends for Thirty Six (36) months from the date of purchase. DAMAGE TO PARTS OR PRODUCTS RESULTING FROM TAMPERING, ACCIDENT, ABUSE, MISUSE, NEGLIGENCE, UNAPPROVED MODIFICATIONS, FIRE OR OTHER HAZARD; IMPROPER INSTALLATION OR OPERATION; OR NOT BEING MAINTAINED IN ACCORDANCE WITH THE MAINTENANCE PROCEDURES SET FORTH IN MANUFACTURER’S INSTALLATION AND OPERATING NSTRUCTIONS VOIDS THIS LIMITED WARRANTY. Exclusion of Other Warranties: MANUFACTURER MAKES NO OTHER WARRANTIES, EXPRESS OR IMPLIED. THE IMPLIED WARRANTIES FOR MERCHANTABILITY, QUALITY OR FITNESS FOR A PARTICULAR PURPOSE, OR ARISING FROM A COURSE OF DEALING, USAGE OR TRADE PRACTICE ARE HEREBY EXCLUDED AND SHALL NOT APPLY TO THE PRODUCT AND ARE HEREBY DISCLAIMED, EXCEPT TO THE EXTENT PROHIBITED BY APPLICABLE LAW. ORAL STATEMENTS OR REPRESENTATIONS ABOUT THE PRODUCT DO NOT CONSTITUTE WARRANTIES. Remedies and Limitation of Liability: MANUFACTURER’S SOLE LIABILITY AND BUYER’S EXCLUSIVE REMEDY IN CONTRACT, TORT (INCLUDING NEGLIGENCE), OR UNDER ANY OTHER THEORY AGAINST MANUFACTURER REGARDING THE PRODUCT AND ITS USE SHALL BE, AT MANUFACTURER’S DISCRETION, THE REPLACEMENT OR REPAIR OF THE PRODUCT, OR THE REFUND OF THE PURCHASE PRICE PAID BY BUYER FOR NON-CONFORMING PRODUCT. IN NO EVENT SHALL MANUFACTURER’S LIABILITY ARISING OUT OF THIS LIMITED WARRANTY OR ANY OTHER CLAIM RELATED TO THE MANUFACTURER’S PRODUCTS EXCEED THE AMOUNT PAID FOR THE PRODUCT BY BUYER AT THE TIME OF THE ORIGINAL PURCHASE. IN NO EVENT SHALL MANUFACTURER BE LIABLE FOR LOST PROFITS, THE COST OF SUBSTITUTE EQUIPMENT OR LABOR, PROPERTY DAMAGE, OR OTHER SPECIAL, CONSEQUENTIAL, OR INCIDENTAL DAMAGES BASED UPON ANY CLAIM FOR BREACH OF CONTRACT, IMPROPER INSTALLATION, NEGLIGENCE, OR OTHER CLAIM, EVEN IF MANUFACTURER OR A MANUFACTURER’S REPRESENTATIVE HAS BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. MANUFACTURER SHALL HAVE NO FURTHER OBLIGATION OR LIABILITY WITH RESPECT TO THE PRODUCT OR ITS SALE, OPERATION AND USE, AND MANUFACTURER NEITHER ASSUMES NOR AUTHORIZES THE ASSUMPTION OF ANY OTHER OBLIGATION OR LIABILITY IN CONNECTION WITH SUCH PRODUCT. This Limited Warranty defines specific legal rights. You may have other legal rights which vary from jurisdiction to jurisdiction. Some jurisdictions do not allow the exclusion or limitation of incidental or consequential damages.