Clarion SRK5 Installation/wire Connection Manual

SRK5 Printed in China IGSRK5 2003 SPECIFICATIONS FEATURES ACCESSORIES SPEAKER INSTALLATION High-powered amplifier with maximum of 50W output power. 5-3/4" full range drivers in the front for high frequency response. 2 low frequency drivers in the rear for mid bass reinforcement. This design delivers clear and stunning sound to your 5.1 surround sound system. Strong neodymium boron magnets are used in the speaker drivers to create powerful playback of audio signals, even though the speaker's drivers are 1" and less in diameter. Included in with the center speaker are mounting brackets and hardware to allow the unit to be installed just about anywhere, including a 1/2 din opening. Item� Q'ty Surface mount screws .........� 8 Bracket mount screws .........� 4 Brackets ..............................�2 Owner's Manual ..................� 1 Warranty Card .....................�1 Amplifier Rated Output� 20W (1kHz @ into 4 Ohm at 1% THD) Maximum Output� 20W Distortion� 0.1% at 1.0W 1kHz� S/N� 70dB (0dB=1kHz 1W 4 Ohm) Input Sensitivity� 200mV to 4V Frequency Response� 200Hz to 29kHz Power Supply Voltage� 10.8V to 15.6V Current Consumption� 3A Dimensions� 1-3/4"H x 3-3/8"W x 5-3/4"L Weight� 1lb Speaker Box Five (5) - 3/4" Full Range Speakers Two (2) - 1" Low Frequency Speakers Peak Power Input ......................� 50W Continuous Power Input .............� 20W Dimensions ...............................� 1"H x 6-3/4"L x 6-1/2"L Weight .......................................� 0.5lb 1. �Determine desired location for speaker box and amplifier � insuring that access is available to all needed items � (i.e. power source, audio signal input, gain control, etc.). 2. �Install speaker box mounting brackets using provided screws � (if needed). 3. �Mount amplifier using provided screws. 4. �Connect the speaker wire from amplifier to speaker's box. 5. �Connect the RCA to your processor or head unit RCA output. 6. �Connect the ground cable from amplifier to a proper grounding � connection on the vehicle chassis. 7. �Connect the DC power to amplifier. 8. �Adjust amplfier gain appropriately. Installation of the unit should not be in a location that would interfere with the vehicle safety air bag or placed in a location that could cause danger or damage to the unit or person. Clear (-) Bracket Installation Surface Bracket Screw Tapping Screw Clear/Red Stripe (+)

www.clarion.com Main Power Supply (Yellow) Ground (Black) Amplifier Control (Blue/White) RCA Input (White) Clear/Red Stripe (+) Clear (-) Clear/Red Stripe (+) Clear (-) CENTER UNIT DVH920 or Head Unit Output (RCA) Center Audio Output Center Speaker Box Center Speaker Amplifier WIRE CONNECTIONS AMPLIFIER INSTALLATION Surface Mount Screw Secure the amplifier unit to the surface with the provided screws. Do not replace amplifier or speaker with any other source. Replacement of incorrect amplifier or speaker may result in potential damage to equipment.