BMPRO JAYCOMMAND Help Manual

Pairing your JAYCOMMAND CONTROLLER, smartphone or tablet to the JAYCOMMAND NODE, is done in three easy steps and the JAYCOMMAND APP will guide you through the pairing process. NOTE: The JAYCOMMAND CONTROLLER will have been paired to your JAYCOMMAND NODE at the factory. You should only need to pair your own device or smartphone to the JAYCOMMAND NODE. While the JAYCOMMAND NODE can be paired to a total of four devices (including the JAYCOMMAND CONTROLLER), you can only pair one device at a time to the JAYCOMMAND NODE. 1. Launch the JAYCOMMAND APP on your phone 2. Using the < or > button on the JAYCOMMAND CONTROLLER, navigate to the “PA” menu item 3. When “PA” appears on the display, press the EXT button to start the pairing process to the JAYCOMMAND NODE, “PA” will blink for a maximum of 30 seconds or until a device is connected. Use < or > to navigate to the 'PA' menu item Figure 3: Press EXT once, to start the pairing process

When pairing a mobile device to the JAYCOMMAND NODE and "--" appears on screen, it is mostly likely that four devices are connected to the JAYCOMMAND NODE simultaneously. To resolve this, either • Close the app on one of the devices that are connected to the JAYCOMMAND NODE and try again, OR • Clear the memory of the JAYCOMMAND NODE of all the previously paired devices. Figure 4: Failed to connect CLEARING JAYCOMMAND NODE OF ALL PREVIOUSLY PAIRED DEVICES WARNING Clearing the JAYCOMMAND NODE memory will also clear the pairing between the JAYCOMMAND NODE and JAYCOMMAND CONTROLLER. After clearing, the JAYCOMMAND CONTROLLER will need to be paired to the JAYCOMMAND NODE again. 1. Go to the JAYCOMMAND APP General Settings and click on Bluetooth Connection 2. Press Unpair RV, to unpair the JAYCOMMAND CONTROLLER from the JAYCOMMAND NODE Figure 5: Unpairing a mobile device from the JAYCOMMAND NODE 3. Navigate to the “PA” function on the JAYCOMMAND CONTROLLER display 4. Press and hold the EXT button until the number 1 scrolls across the JAYCOMMAND CONTROLLER display. The JAYCOMMAND NODE is now clear of all connected devices.

until the number 1 scrolls across the JAYCOMMAND CONTROLLER 5. Pair the JAYCOMMAND CONTROLLER to the JAYCOMMAND NODE again. Please refer to the Pairing to the JAYCOMMAND NODE. 6. Pair the new device to the JAYCOMMAND NODE, (please refer to the Pairing to the JAYCOMMAND NODE). After pairing successfully completes, you will see the home screen of the JAYCOMMAND APP The Bluetooth icon will appear in the indicated location Figure 7: JAYCOMMAND CONTROLLER Home screen after pairing successful .