Sharp FO-2950M - B/W Laser - All-in-One Operation Manual

134 MEMORY IS FULL The memory is full. This may occur during fax reception if too much data is received before the pages can be printed out. If faxes have been received to memory because printing is not possible (an additional message will indicate the problem), resolve the problem so that printing can continue (see Substitue Reception to Memory in Chapter 3). If you are attempting to transmit by automatic dialling, see If the memory becomes full in Chapter 2. MEMORY PRINTING The fax is preparing to or printing out a document from memory. NO DATA This appears if you attemp ...

104 Polling (Requesting a Fax Transmission) Polling allows you to call another fax machine and have it send a document to your machine without operator assistance. In other words, the receiving fax machine, not the transmitting fax machine, initiates the transmission. You can use your fax machine to both poll and be polled by others. To use the polling function, you must first set Rapid Key 16/POLL for use as a polling key. 1 Press these keys: The display will show: 2 Press 1 to turn on the function, or 2 to turn it off. 4 FUNCTION or YES NO 1 2 POLLING ...

the condition for printing. ALWAYS PRINT A report will be printed after each transmission, reception, or error. ERR/TIMER/MEM A report will be printed after an error, timer operation, or memory transmission. SEND ONLY A report will be printed after each transmission. NEVER PRINT A report will never be printed. ERROR ONLY A report will be printed only when an error occurs. 3 Press the STOP key to return to the date and time display. 4 5 3 1 2 STOP all-fo2950a.book Page 119 Thursday, March 23, 2000 5:38 PM ...

whenever information on 30 operations has accumulated. (A report can still be printed on demand at any time.) Follow the steps below: 1 Press these keys: The display will show: CANCEL - The transaction was cancelled because the STOP key was pressed, no document was in the feeder, or the other machine requested transmission using a function which your fax machine does not have. If you were attempting to fax, make sure a document is in the feeder. If you were receiving, contact the faxing ...

128 Dialling and transmission problems Problem Solution No dial tone when you pick up the handset or press the SPEAKER key. • Make sure the handset cord is connected to the correct socket. See Connecting the handset in Connections in Chapter 1. Dialling is not possible. • Make sure the power cord is properly plugged into a power outlet. • Make sure that the telephone line is properly connected to both the TEL. LINE socket and the wall socket. • Make sure that the fax machine is set to the correct dialling mode for your telephone line. See Connecting the telephone ...

27 1. Installation Installing the Multifunction software Minimum system requirements Processor: Pentium 90 MHz or higher Operating system: Windows 95/98, Windows NT 4.0 (Service Pack 3 or later), English version Physical RAM: Windows 95/98: 16 MB Windows NT 4.0: 32 MB Free hard-disk space: Windows 95/98: 30 MB Windows NT 4.0: 35MB ♦ Before installing the software, read the README.TXT file on the CD. It contains important last-minute information on installing and using the Multifunction system. ♦ The Sharp Laser Multifunction software cannot be i ...