Piper Navajo Chieftain PA-31-350 Maintenance Manual

1. Turn the heater control switch off. 2. Remove the access panel located on the right side of the nose section. 3. Open the forward baggage door and remove the access panel located on the right rear side of the baggage compartment door. 4. Loosen the shroud cover of the fuel inlet line fitting located on the forward upper left side of the heater. Disconnect the fuel line from the heater. 5. Remove the screws that secure the forward end of the heater to the fuselage bulkhead plate assembly. 6. Disconnect the air inlet valve cable atta ...

thinner. Air dry 4-6 hours at 75°F or force dry 2-3 hours at 125°F before top coating with Jet-G1o. D. Tack wipe surface before applying topcoat. E. Mix Ameron Jet-Glo polyurethane enamel to manufacturer's directions. Reduce with 110-655 thinner to a viscosity of 17-20 seconds using a No. 2 Zahn Cup at 75°F. F. Apply Jet-Glo to a spreading rate of approximately 300 sq. ft/gal. to attain a 2.0 mil. dry film thickness. A recommended pot pressure of 10-13 PS ...

turbochargers installed on the T-1020. DESCRIPTION AND OPERATION. The Turbocharger System consists of a turbine and compressor assembly, an automatic waste gate control and the necessary hose and engine air intake ducts. The turbocharger system requires little attention between turbo overhauls. However, it is recommended that the items outlined in the Inspection Report be checked during required inspection intervals. Should trouble occur, refer to ...