Avid Technology S6 Assembling/disassembling

23 Detaching Leg Frame Join Modules To detach Leg Frames that include a Leg Frame Join Module: 1 Detach the left frame from the bracket by removing the eight fasteners and washers (see Figure 18). 2 Repeat for any other pairs of Leg Frames attached to each other with a Leg Frame Join Module. Removing the End Brackets If you are adding one or more Leg Frame Extensions to an existing Leg Frame, you only need to remove one or both End Brackets. To remove the End Brackets:  Remove the eight fasteners and washers per bracket that attach the Left ...

25 Removing the Back Corner Brackets If you are disassembling the Leg Frame to move or expand it, detach or remove the Back Corner Brackets. To remove the Back Corner Brackets:  Detach the Back Corner Brackets from the legs (see Figure 21) by removing the four fasteners and washers per bracket. • If you are moving the frame (not expanding it), leave the brackets attached to the Beam and then lift the Beam off the Legs. • If you are expanding the frame by replacing the Beams, fully detach the Back Corner Brackets from the Beam by removing ...

12 Disconnecting Cable Sets To disassemble a frame to move or expand a system, you should disconnect and remove all Cable Sets. To disconnect Cable Sets: 1 Standing behind the system, start at either end and disconnect the Ethernet Cable Set from the back of the first chassis (far left or far right). 2 Disconnect the other ends of that Cable Set from the S6 network switch, taking note of its switch ports. You do not have to reconnect to the same switch ports but doing so can simplify re-assembly. 3 Place the removed Cable Set aside. 4 Move ...