BluStream DA11AU Quick Reference Manual

01 contact [email protected] / [email protected] Our DA11AU has been designed to convert unbalanced or balanced 2ch analogue audio to Dante® digital signal. The DA11AU allows any non-Dante® audio source such as mixing consoles, amplifiers, computers and Blustream Matrix products or distribution products to be connected as a source within a Dante® network. The DA11AU is a plug & play device that is powered using PoE (Power Over Ethernet) from any PoE network switch and supports AES67 RTP audio transport. Introduction • Analogue audio inputs support both balanced and unbalanced audio signals • Supports 44.1, 48 & 96 KHz sample rates @ 24 Bit • Configurable Dante® device latency (supports 1, 2 or 5ms configurable using Dante® Controller) • Supports AES67 RTP audio transport • Features Class 1 802.3af PoE for powering of product from any PoE switch DA11AU Quick Reference Guide FEATURES: Connections: 1 Dante® Audio Output - RJ45 socket connets to your Dante® network. 2 Audio Input - Phoenix Connector accepts balanced or unbalanced 2 channel audio input. Front Panel 1 Rear Panel 2

02 www.blustream.co.uk Dante Controller Dante Controller software is required in order to setup and configure the DA11AU as well as control your Dante network. Audinate provide extensive training videos and documentation on their website. This can be found here: http://www.audinate.com/products/software/dante-controller Upon connecting your DA11AU to a compatible network, the Dante Controller software should automatically discover the device. The DA11AU will appear in the Dante Controller with a name denoted with “BLS”. On the “Routing” screen you can create audio routing between Dante transmitters and receivers in your system. By default the DA11AU is shipped with its network settings set to obtain an IP Address automatically. This means that if a DHCP server is present on your network, it will provide the DA11AU with an IP Address. If no DHCP server is present then the DA11AU will receive a default IP Address in the 169.254.xxx.xxx range. To change the IP Address of the DA11AU, you must enter the “Network Config” menu in the “Device Info” screen of the Dante Controller software.

03 contact [email protected] / [email protected] RevA0_QRG_HD12DB_190606_Web Layout Advanced Dante Settings It is also possible to change the settings of the DA11AU under the “Device Info” screen in the Dante Controller software. To do so, select the “Device Config” menu. Here we can adjust the sample rate of the DA11AU. Please note that Dante products can only transmit or receive audio from other Dante products that are set up with the same sample rate. A mismatch in sample rate may stop audio from transmitting. Under the “Device Config” screen we can also adjust the latency of the DA11AU from 1, 2 or 5 milliseconds. Depending on your audio input device, it may be necessary to adjust the Input Sensitivity of the DA11AU. Under the “Controls” screen we can adjust the input sensitivity of each channel from the default of +24dBu to -10dBV.

04 www.blustream.co.uk Specifications Audio Input Connectors: 6-PIN Phoenix connector (2ch balanced/un-balanced analogue audio) Audio Output Connectors: 1 x RJ45, female (100 Mbps Dante® network) Casing Dimensions (W x H x D): 120mm x 23mm x 34mm Shipping Weight: 0.2 Kg Operating Temperature: 32°F to 104°F (0°C to 40°C) Storage Temperature: - 4°F to 140°F (- 20°C to 60°C) Power Supply: Class 1 IEEE 802.3af POE PD Package Contents • 1 x DA11AU • 1 x Quick Reference Guide Acknowledgements Dante® is a registered trademark of Audinate Pty Ltd. Example Schematic