LabelTac Pro X Quick Start Manual

®- LET’S START LABELING 1 | UNBOX & CHECK CONTENTS 2 | CONNECT 3 | INSTALL SOFTWARE QUICK START GUIDE LabelTac® Pro X Thermal Transfer Printer Included Accessories Option 1: Install from CD Option 2: Digital download Insert the USB cable to the back of your printer and plug the other end into a USB port on your computer. Put the included CD in your computer’s CD drive and follow the prompts on your screen to install the software. Head to the LabelTac® support page, select your printer model, and download the driver for your printer.  labeltac.com/support Connect the the two halves of the power cable and plug into the power jack socket. Plug the other end into an electrical outlet. Power on your printer. Note: It is important that your LabelTac® printer is powered on before installing software. Cleaning Swabs (2) USB Cable Power Cable Software CD 1 2 3 DOWNLOAD THE USER MANUAL The full LabelTac® Pro X User Manual can be downloaded online at  labeltac.com/manuals SUPPORT Your LabelTac® printer includes a free, full lifetime warranty on all parts and labor and unlimited support by phone, email or live chat. Online Support labeltac.com/support Support by phone 1-877-356-6584 Support by email [email protected] Label Squeegee

HOW TO | LOAD PRINT RIBBON Open the printer using the two cover latches. Spread the supply holders apart by sliding the arms. Both arms will separate evenly. Insert the roll of supply as shown. The holders will close to retain the roll. Your printer holds ribbon in place using two black plastic cores. Insert one plastic core into your print ribbon, and the other into the blank core included in the ribbon box. Route the supply under the supply guides. Adjust the guides by sliding back or forth as needed to keep the supply centered. Continue routing the supply over the black platen roller. The end of the supply should stick out a little at the front of the printer. Open the printer. Then open the ribbon access cover and media cover. Insert the ribbon into the rear ribbon hub by pressing the right side of the ribbon into the spring loaded holder. The left side of the roll goes onto the yellow hub. Now insert the blank core into the upper ribbon hub in the same fashion. Pull the end of the ribbon down through the printer and up and over the blank core. New rolls have an adhesive edge to attach to the blank core, otherwise use tape. Wind the core up until the ribbon is tight. 1 1 Check out videos on loading supplies and learn some helpful label making tips on our YouTube channel  youtube.com/labeltac 2 2 3  labeltac.com/support  1-877-356-6584 Need some more help with your printer? Cover Latch Ribbon Access Cover Media Cover