Petsafe Electronic SmartDoor Installation Manual

Extension Tunnel 1. Insert the Electronic SmartDoor™ into the lip of the Tunnel Extension as shown (3A-1). 2. Tape the Tunnel Extension to the Electronic SmartDoor™ (3A-2). Note: Rear Door Frame of SmartDoor™ will not be used in wall installation. 1 2 ______________________________________________________________________________ Install the Assemblies into the Wall 1. From outside the home, insert the Outside Frame into the wall. Check for plumb (vertical) and level (horizontal) before installing any screws. 2. Have a helper hold the frame ...

EXPRESS WARRANTIES. PetSafe® EXPRESSLY DISCLAIMS AND EXCLUDES ALL OTHER WARRANTIES, EXPRESS OR IMPLIED, INCLUDING WITHOUT LIMITATION, THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. PetSafe® ALSO DISCLAIMS AND EXCLUDES ALL LIABILITY FOR INCIDENTAL, CONSEQUENTIAL, PUNITIVE, DIRECT, INDIRECT, SPECIAL OR ANY OTHER DAMAGES ARISING OUT OF OR CONNECTED WITH THE PURCHASE, USE OR MISUSE OF THIS PRODUCT OR FOR THE BREACH OF ANY EXPRESS OR IMPLIED WARRANTIES OR BREACH OF CONTRACT OR OTHERWISE. PUR ...

Extension Tunnel 1. Insert the Electronic SmartDoor™ into the lip of the Tunnel Extension as shown (3A-1). 2. Tape the Tunnel Extension to the Electronic SmartDoor™ (3A-2). Note: Rear Door Frame of SmartDoor™ will not be used in wall installation. 1 2 ______________________________________________________________________________ Install the Assemblies into the Wall 1. From outside the home, insert the Outside Frame into the wall. Check for plumb (vertical) and level (horizontal) before installing any screws. 2. Have a helper hold the frame ...

Refer to the operating instructions that accompanied your Electronic SmartDoor™ purchase for detailed instructions on operating your door, and training your pet. _______________________________________ Additional Parts Available Component Part No Wall Extension Tunnel, Large CPA00-12021 Step 5 ...

1. Locate the site for your SmartDoor™ Wall Entry installation and verify accessibility for your pet both inside and outside. Note: Check both indoors and outdoors for electrical wiring or pipes in the wall area in which you wish to install the Pet Door. If necessary, cut a small hole in the wall to verify the stud location and that no wiring or plumbing exists. 2. Locate the edge of one stud in the proposed area with a stud fi nder. Using a pencil, draw a 5” vertical line on the edge of the stud about 10” to 12” above the fl oor (1A). 3. ...

of outer wall to the inside of inner wall as shown to determine stud thickness (2A). 2. Cut a 2" x 4" or 2" x 6" piece to the width of the opening, making sure that the cut is square. 3. Remove any debris that may be inside the wall where the supports will be located. 4. Place support inside wall 2A 2B so that the top of support is fl ush with the bottom of cut-out. 5. Use 2 decking screws to fasten the inner side of each support as shown (2B). Check again to make sure that the supports are fl ush with bottom of cut-out (2B). 6. M ...

10427 Electric Avenue Knoxville, TN 37932 1-800-732-2677 www.petsafe.net 400-1103 ©2008 Radio Systems® Corporation ...

the template is level and that this is the best possible location for the Pet Door. Keep in mind you are cutting a hole from the inside edge of one stud to the inside edge of its neighboring stud. In common framing, this space should measure about 14 1/2”. 7. Drill the 4 corners all the way through the inside and outer walls. Use a 5/16" drill bit, and use the framing square to be sure you keep the drill level and perpendicular to the wall (1F). 8. Carefully cut the hole out using a jigsaw or other appropriate cutt ...