PerkinElmer Lambda 365 Installation Instructions Manual

environmental conditions for the operation. 2. Open the lid of the coolant inlet on top of the Peltier Controller. Figure 7 Lid of coolant inlet 3. Fill up the liquid coolant. CAUTION ATTENTION Liquid coolant should be used as refrigerant. Do not use any water (tab water, DI, etc.). If water is used as refrigerant, the Peltier Controller’s components might be corroded and its performance may be deteriorated. Use any kind of liquid coolant of normal grade that is avail ...

6-Position Peltier Controlled Cell Changer (with heated reference or without heated reference) Peltier Controller Power Cord, 3ea Interface Cable (RS-232 and USB to RS-232), 1each Spare Fuse (AC 250V T5AL), 2ea Temperature Probe, 1ea Magnetic Stirrer, 6ea Coolant Hose, 1ea Coolant, 2ea Waste Basket for Coolant, 1ea Waste Hose for Coolant, 1ea Phillips round head screw with washer, 2ea Description 6-Position Peltier Controlled Cell Changer (with heated reference or without heated reference) Figure 2-1 Lambda 365 6-Position Peltier ...

Figure 5 Front view a. Manual touch pad with Display: Temperature Control Unit (Heating/Cooling Block). b. LED Indicators: Display the status of the operation of Coolant Circulation, Fan, Pump, etc. (If there is any problem in the components, Red LED will flash with beep alarm.). c. Manual ON/OFF button: As the Manual ON/OFF button is ON, the temperature can be controlled manually by a) Manual touch pad with Display. NOTE: Manual operation is used only for the manufacturer so it should be turned off during the measurement. d. N2 ...

1. Check if the 6-Position Peltier Controlled Cell Changerconnector is connected to the Lambda 365. 2. Turn on and off again the Lambda 365 with installed 6-Position Peltier Controlled Cell Changer. Intensity is too low 1. Recalibrate if the light beam does not reach the center of the cell holder’s hole. 2. If the intensity value is still low after the recalibration, the lamps of the light source may be deteriorated and need replacing. Contact Perkin Elmer or the nearest representative. When 6-Position Peltier Controlled C ...

Setting USB to RS-232 Cable NOTE: When using the RS-232 cable, the COM Port is set automatically. When using the USB to RS-232 cable, USB to RS-232 Driver has already been installed when installing the Lambda 365 and UV Express software, user does not need to install it again. When the communication by the USB to RS-232 converter is not established, change the port setting as follows; 1. Select My Computer →Properties. 2. Select Device Manager. ...

then baseline (or zero) will be measured when it reaches the set Temperature. NOTE: To monitor the probe temperature, the probes should be immersed in the sample, or to use the block temperature for monitoring, the cell lid should be closed tightly. a. Start Temp (°C): The starting temperature of experiment. b. SP Temp (°C): The set temperature to go to the next measurement temp. c. Block Temp (°C): The temperature of Cell Block. d. Probe 1 Temp (°C): The temperature of ...