GEZE ECturn Mounting Instructions

X X cables! Before working on the electrical system, disconnect the system from the mains network. X X If it exists, unplug the battery. X X In accordance with the valid regulations it must be possible to deenergize the door drive at a suitable point. àà In the case of a fixed connection by the customer, provide an all-pole disconnecting device. X X If flexible cables are used, always use insulated wire-end ferrules. X X Plug in the power plug (32). X X If ...

8.2.2 Fixing with mounting plate Direct fi xing                            14 Dimensional reference hinge middle 15 Cable entry for power supply cable 16 Cable entry for control cables Observe drilling template: DIN left and DIN right mirrored. X Fastening means Mounting plate M5 à Base plate M5 or chip board screws à Guide rail M5 or chip board screws à Take drive orientation into account: Motor towards hinge. X Required space 17 ECturn required space 19 Required ...

8.8 Loosen bolts (27 ). X X Remove the cover (28) for the side element. X X Break out the breaking point (29) in the cover (28). X X 38 38 39 38 3: Unscrew the nut (31) at the door transmission cable (30). X X Thread the door transmission cable (30) through the cover (28). X X Screw the nut (31) tight in the cover (28). X X 41 42 Loosen the strain relief (33). X X Loosen the screw (34) and pull off the protective conductor. X X Loosen the cable at the terminal strip (35). X X Remove the power plug (32) with cable. X X 43 44 45 ...

If a fault is currently active, it is shown every 10 seconds on the display programme switch. If the dot lights up in the left half of the display programme switch, the system was unable to completely initialise after being switched on. Either there is an obstruction or something in the system itself has become jammed. The dot extinguishes as soon as the door has been opened completely and closed again once. For troubleshooting and elimination: see fault table in the wiring ...