DSE STORM 2000 Operation & User’s Manual
Text of the manual
STORM 2000 RGB LED STROBE
USER MANUAL
Please read the instructions carefully before use.
all-guides
com
TABLE OF CONTENTS
1. Safety Instructions 1
2. Technical Specifications 4
3. How to Control the Unit 6
4. Shape
The power plug has to be accessible after installing the fixture. Do not
overload wall outlets and extension cords as this can result in fire or electric
shock.
DO NOT allow anything to rest on the power cord. DO NOT locate this
fixture where the cord may be damaged by persons walking on it.
Make sure that the power cord is never crimped or damaged by shar
The fixture becomes very hot during operation. Allow the fixture to cool
approximately 20 minutes prior to manipulate with it.
Operate the fixture only after having familiarized with its functions. DO
NOT permit operation by persons not qualified for operating the fixture. Most
damages are the result of unprofessional operation.
Please use the original pac
2. Technical Specifications
FEATURES
• Super bright output via 1260 RGBW LEDs
• Intense built-in strobe programs + random strobe
• 2-segment pixel modes can safely be used as wash (about 400W)
• Built-in over heat protection temperature sensor to extend the lamp life
• Variable electronic strobe & 16-bit dimmer
• User adjustable flash rate of 0
Master Dimmer (0-100%)
---
--
---
--
---
--
2
2
2
Red segment Intensity (0-100%)
---
--
---
--
---
--
3
3
3
Green segment Intensity (0-100%)
---
--
---
--
---
--
4
4
4
Blue segment Intensity (0-100%)
---
--
---
--
---
--
5
5
5
White segment Intensity (0-100%)
---
--
2
2
6
6
6
Flash duration (0-full on)
1
3
3
7
7
7
Strobe rate (0-30Hz)
---
--
---
Before replacing a fuse, disconnect
power cord, always replace with the
same type and rating of fuse.
3. How to Control the Unit
FUSE REPLACEMENT
CAUTION! The Storm1000 utilizes a high-output switch-mode power supply
with an internal fuse. Under normal operating conditions, the fuse should not
require replacement. The fuse is field replaceable, however
Cables must have a male XLR connector on one end and a female XLR
Connector on the other end.
A word on Termination: DMX is a resilient communication protocol, however
errors still occasionally occur. Termination reduces signal errors, and therefore
best practices include use of terminator in all circumstances. If you
experiencing problems with erratic fix
SETTING UP DMX CONTROL
STEP 1: Connect the male connector of the DMX cable to the female
connector (output) on the controller.
STEP 2: Connect the female connector of the DMX cable to the first fixture’s
male connector (input).
Note: It doesn’t matter which fixture address is the first one connected. We
recommend connecting the fixtures in terms of the
first fixture in the chain be initialized for this purpose via either settings in the
control panel or DIP-switches. Secondarily, the fixtures that follow may also
require as lave setting. Check the “Operating Adjustments” section in this
manual for complete instructions for this type of setup and configuration.
.
MOUNTING AND RIGGING
This fixture can